To Turn Off Gas To Appliance; Manual Lighting Procedure - Desa CF18PV Owner's Operating & Installation Manual

OPERATING
HEATER
Manually-Controlled
Models
Continued
26
7. Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds,
release control knob.
• If control knob does not pop out when released, contact a qualified service
person or gas supplier for repairs.
Note: If pilot goes out, repeat steps 3 through 7.
Thermocouple
8. Push in and turn control knob counterclockwise
Both burners should light. Set control knob to desired setting.
VARIABLE CONTROL OPERATION
The variable control valve can be set to any heat setting and flame height desired, by
simply turning the control knob until that setting is attained. Even the lowest setting
provides realistic flames and glowing embers from two burners. Selecting higher
settings produces greater heat output. This results in increased heating comfort.
Do not operate heater between locked positions.
Do not try to adjust heating levels by using the manual shutoff valve.

TO TURN OFF GAS TO APPLIANCE

Shutting Off Heater
1. Press in and turn control knob clockwise
2. Turn the control knob clockwise
3. Press in control knob and turn clockwise
Shutting Off Burners Only (pilot stays lit)
1. Turn the control knob clockwise
2. Press in and turn control knob clockwise

MANUAL LIGHTING PROCEDURE

1. Follow steps 1 through 5 under Lighting Instructions, page 25.
2. Depress control knob and light pilot with match.
3. Keep control knob pressed in for 30 seconds after lighting pilot. After 30
seconds, release control knob. Now follow step 8, above.
Ignitor Electrode
Figure 30 - Pilot
C-clockwise
WARNING
WARNING ICON G 001
CAUTION
WARNING ICON G 001
to the HIGH position.
Clockwise
to the PILOT position.
Clockwise
to the OFF Position.
Clockwise
to the HIGH position.
Clockwise
to the pilot position.
Clockwise
Pilot Burner
to the HIGH position.
102653