Insert The Sim Card; Install The Battery; Charge Your Battery - Iridium GO! Quick Start Manual

Step 1: Set up your Iridium GO! device
Refer to User Manual Chapter 2 for important safety information on the proper use and disposal of batteries.
4 Iridium GO! Quick Start Guide

Insert the SIM card

1. Remove the battery cover with a flat blade screw-driver, or a small coin.
2. Slide SIM card-holder toward the hinges, and lift to open.
3. Insert SIM card into slot, close card-holder, and slide it away from the hinges
to lock.

Install the battery

1. Install the battery with the gold battery contacts facing down over the four
connector contacts.
2. Replace the battery cover, and ensure screws are firmly tightened to maintain
correct water resistant seal.

Charge your battery

1. Open the USB cover and firmly plug in the USB cable.
2. Connect the USB cable to the Travel Charger or Car Charger provided.
3. Finish charging, remove USB cable, and close USB cover.
Important: Keep the battery charged to ensure that the device is ready for use
when needed.