Rodak CleanStation 5 Instruction Manual

IMPORTANT NOTES

Attention: Before assembly and starting operation, read the operating instructions carefully.
Check that the mains voltage corresponds to the details on the type plate.
Only connect to proper 230 volt, 50 Hz.
Minimum fuse protection 10 A.
Pull the mains plug out of the socket when : the unit is not in use, before cleaning and
maintenance.
Never clean the unit with solvents.
Do not use the cable to pull the plug out of the socket.
When unit is ready for use, do not leave it unattended.
Safeguard from children.
Care must be taken that the mains connection lead is not damaged by being driven over,
crushed, stretched etc.
The unit must not be operated if the mains connection lead is not in perfect condition.
On no account vacuum: burning matches, glowing ashes and cigarette ends, inflammable,
corrosive, fire hazard or explosive substances, vapours, liquids and strong foaming
substances.
This unit is not suitable for vacuuming dust which is damaging to health.
Store the unit in a dry place.
Do not operate a defective unit.
Servicing only by an authorized after-sales service point.
Unit should be used in dry place.
Damaged mains connections cable must be replaced by qualified person only.
Use only for operations for which the unit is intended.
Great care must be taken when cleaning stairs.
Use only manufacturer's attachments and spare parts.
Keep nozzles and tube ends properly covered.
Never use unit without filters.
Parts conducting electricity (supply cord, plug, motor, switch) should never come into
contact with water.

COMPONENTS DESCRIPTION:

1 Handle
2 Exhaust opening
3 Hose connector
4 Flexible vacuum hose
5 Wheels
6 ON / OFF switch
7 Supply cord
8 Supply cord holder
9 Float
10 Filter basket
11 Head
12 Hook fastener
13 Vacuum tubes ( 2 pieces)
14 Tank
15 Combi Brush
CleanStation 5

Instruction manual

Wet & dry vacuum cleaner
3
4
13
14
5
15
2
11
12
™
1
6
7
8
9
10