Making A Song; Sync Multiple Units; Copy Pattern; Sync Modes - teenage engineering PO-12 User Manual

5 – making a song

copy pattern

hold write + pattern and
press 1-16 to paste the
active pattern to the
corresponding new slot.
6 – sync multiple units
sync
SY1
output
master
it is possible to sync
multiple pocket operators
with a click track using line
in and out.
warning: sync levels should
not exceed 6.0V (peak-
to-peak).
sync scenarios
SY1
clear pattern
press funct + pattern to
clear the active pattern.
SY4
input
slave
connect a standard stereo
audio cable between the
units. the master unit will
control the tempo of the
slave unit.
SY5 SY4
chain pattern
pattern
press and hold pattern and
select which patterns 1-16
to chain by pressing the
corresponding key 1-16. up
to 16 patterns can be
chained.
hold funct and press bpm
on master unit to toggle
sync modes. press
repeatedly to toggle
between different modes.
external
1-16
one pattern can be selected
multiple times. example
1,1,1,4 plays pattern 1 three
times then moves on to
pattern 4. after last pattern
is played the sequence will
start over again.

sync modes

ID input output
SY0 stereo stereo
SY1 stereo mono/sync
SY2 sync stereo
SY3 sync mono/sync
SY4 mono/sync stereo
SY5 mono/sync mono/sync
there are 5 sync modes.
default mode is SY0.
when sync is used the
signal will be split between
audio (right) and sync
(left).
SY2