Advertisement
Make sure to use only shielded cables whether balanced or unbalanced. Shielding when properly grounded protects a signal against
external radio interference, interference generated by dimmers and other electric noise. Avoid placing input cables close to power
cords or power transformers.
As a rule, unbalanced lines of over 3 meters long are not acceptable. Greater distances require a balanced cable.
Unbalanced connection models with XLR input connectors, contact 3 (Cold "-" ) need to be mutually connected with base contact 1
(Ground)
SPECIFICATION
TITLE
Output power
Sensitivity
Maximal musical
pressure
Built-in amplifier
Total harmonic
0,05% (45 Hz- 20 kHz, 8 Ohm) 0,05% (45 Hz- 20 kHz, 8 Ohm) 0,05% (45 Hz- 20 kHz, 8 Ohm)
distortion
Input connectors
Input sensitivity
Input impedance
Frequency range
Filter
Components
Corps material
18 mm Baltic birch plywood
Material
Dimensions (WxHxD)
Weight
CONTROLS AND CONNECTORS
SUB PF118
1400W (8 Ohm, 230V)
98dB 1 W/m
130dB
Class D
2x female XLR
2x male XLR
0,775V (RMS)
10k Ohm (symmetric)
45Hz- 80...250 Hz
24dB/Oct
1xFaital 18FH1060 8 Ohm
Black structured color
540x605x670mm
44kg
SUB MP112
700W (8 Ohm, 230V)
96dB 1 W/m
128dB
Class D
2x female XLR
2x male XLR
0,775V (RMS)
10k Ohm (symmetric)
45Hz- 80...250 Hz
24dB/Oct
1xFaital 12FH500 8 Ohm
18 mm Baltic birch plywood
Black structured color
390x460x590 mm
24kg
1 POWER . power switch.
2 MAINS IN . power cable socket.
ATTENTION! The power to the amplifier is supplied from single-
phase AC power mains
with protective grounding. To connect the amplifier to awall outlet,
first insert the power
cord into the power cord socket and then plug it into the wall outlet.
3 Channel B line output (XLR male): parallel to Channel B input.
4 Channel A line output (XLR male): parallel to Channel A input.
5 Channel A input (XLR female)*.
6 Channel B input (XLR female) *.
7 LOW PASS FILTER . low-pass filter cutoff point knob: sets the
bandwidth upper
frequency (80Hz ... 350Hz).
8 BASS LEVEL . input level control knob.
Used to adjust the level of the input signal applied to the power
amplifier.
9 CLIP / THERM. overload/ thermal protection LED
Indicating:
. overload condition characterized by sound distortion and
optoelectronic clip-limiter
active mode; thermal protection active condition. (See: Thermal
Protection above).
10 POWERLED.
In case of active DC protection system, the LED goes off.
11 PHASE . output signal phase slide switch. Used to set the
required phase of the output
signal:
. + . signal phase unchanged;
. . . signal phase 180° reversed.
SUB MP115
700W (8 Ohm, 230V)
96dB 1 W/m
128dB
Class D
2x female XLR
2x male XLR
0,775V (RMS)
10k Ohm (symmetric)
45Hz- 80...250 Hz
24dB/Oct
1xFaital 15FH500 8 Ohm
18 mm Baltic birch plywood
Black structured color
450x500x615mm
34kg
Advertisement
