Philips 237E4QSD/93 Service Manual page 72

Meridian 4
72
MECHANICAL CHARACTERISTICS
Philips ID
ProE files required
Per Philips make-up sheet
< 1.2mm(typ.)
Per Philips Graphic sheet
Per Philips make-up sheet
Shielding Cover should fulfill international standard
 RoHS required
 WEEE required.
 Resin type/selection refer to Project Book Section 7.2 Plastic material.
 RoHS required
 WEEE require
 If new painting type need to implement, refer to UN-D 1235.
 Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld
lines, gate marks, ejector marks, etc.). Refer to "TYV61-90007".
 Painting to cover up cosmetic defects due to molding is strongly discouraged.
 China RoHS mark requested.
 All Plastics to be Flame Retardant UL 94-HB or Better.
 Base / Pedestal to be Flame Retardant UL 94-HB.
 All major plastic parts (bezel, back cover) need to be molded from same resin.

Plastic resin type selection should be referred to "plastic-Philips Pool monitor".
 The texture area and texture no should follow Philips make-up sheet.
 The exterior surfaces shall have a uniform texture.
Cosmetic -
Mechanical data files -
Location of Philips logo -
Gap between panel and front bezel
Location of Control icons -
Color for resin/paint -
Fire enclosure request
Resins
If paint is used
Plastic mold tooling
Plastics flammability
Texture/Glossing of housing