Download Print this page

Advertisement

Quick Links

Instruction Manual
Product & Accessories
(121201006 White / 121201007 Black)
Scent Pot Scentilizer
®
• Please check if all following items are present and if there is any damage before use.
Lid
Spray hole
Power
Time Setting
(ON / OFF)
button
ON / OFF
60
Main unit
Power
Timer setting
indicator
Control panel
LED light
Atomizer
Ventilation
inlet
Power
Lid slot
Vent

Operating Instructions

• Always place your Scentilizer
• Condensation may occur around the Scentilizer
1
2
3
Scent Pot
Scentilizer
®
Design by
Carsten Jörgensen
4
5
Light Setting
Cleaning brush
button
AC adapter
90
120
6
indicator
Lid
7
Water tank
Water mark
(100ml)
®
on a firm, flat, and level surface.
®
when operating in high humidity environment.
Turn the cover counter clock wise to remove it from
the main unit ( as show in diagram ) Remove the Lid
from water tank.
Plug the head of the AC adapter into the power jack
at the bottom of the main unit.
Fill water tank to its maximum(MAX)water mark
level. To avoid damage to this device, never fill water
exceeding its maximum water mark level.
• Use tab water or mineral water.
• Fill with bottled or filtered water up to the water indicator
line.
• Water should be in room temperature(25℃ ~ 40℃)
(76.9˚F ~ 103.9˚F). Do not use water below 25℃
(76.9˚F).
• After completing the water filling procedure, please wipe up
any excess moisture on the sink.
• Never add water into the vent hole.
Add 5-10 drops of SERENE HOUSE 100% natural
essential oil into the water tank. Cover the tank with
Lid. Please do not let essentiall oil drip onto the
exterior of Scentilizer
®
If essential oils accidently
dripped onto the exterior of the device, wipe clean
immediately with a cloth.
• Never allow water or oil to enter the vent.
Close the cover by match the marking on the cover
and main unit.Turn clock wise to Lock in place.
• Please note that the lid must be attached in a certain
orientation. It will not be attached correctly if not
performed according to the diagram.
• Please note that atomization may fail or be insufficient if the
lid is not attached securely.
Plug the AC adapter into a power outlet and press the
power button to turn the power on. The built-in LED
light and power indicator will be on when the device
starts to operate.
• The built-in LED light can be turned off during use by pressing
ON / OFF
60
90
120
the light setting button.
• For safety purpose, this Scentilizer
®
is programmed to stop
operating automatically when it detects the water is below
its programmed level.
Please empty the water in the water tank and follow
step 1 to 6 when reuse this device.
• For proper handling and maintenance, please refer to the
Cleaning & Maintenance section this manual.
Light Setting Instruction
ON / OFF
60
90
120
ON / OFF
60
90
120
1. To Turn On - Press the light setting button and the built-in LED light will light up.
2. To Turn Off - Press the light setting button and the built-in LED light will go off.
3. The built-in LED light can be turned off during use by pressing the light setting button.
4. The light will automatically turned off with the unit when, the water level is low.
Time Setting Instruction
ON / OFF
60
90
120
ON / OFF
60
90
120
To set the usage time of this Scentilizer
®
.
1. Press the time setting button once for 60-minutes operation. The 60 timer indicator will go on.
2. Press the time setting button twice for a 90-minutes operation. The 90 timer indicator will go on.
3. Press the time setting button three times for a120-minutes operation. The 120 timer indicator will go on.
4. Press the time setting button four times for continuous operation.
5. For safety purpose, this Scentillizer is programmed to stop operating automatically when it detects the
water is below its programmed level.
Caution
• NEVER connect the power without covering the lid and the cover.
• Do not remove the lid or block the Ventilation inlet under the main unit during use.
• When the device is in operation and there is water in water tank, do not touch the atomizer as personal injury
or device malfunction may occur.
• Make sure to pour out the water that has been using for over 24 hours.
• For best performance, we recommend SERENE HOUSE essential oils with this Scentilizer
essential oils may cause damage to the device.
• Make sure to wipe clean with a cloth if oil drips on the main unit or floor.
Light Setting button
Time Setting button
Timer setting indicator
®
. Use of other

Advertisement

loading
Need help?

Need help?

Do you have a question about the Scent Pot and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Serene House Scent Pot

  • Page 1: Operating Instructions

    • The built-in LED light can be turned off during use by pressing Control panel ON / OFF • For best performance, we recommend SERENE HOUSE essential oils with this Scentilizer ® . Use of other the light setting button.
  • Page 2: Safety Precautions

    Check the water type used and water temperature For best performance of this Scentilizer ® , we recommend using SERENE HOUSE essential oils. → Please use bottled or filtered water between 25°C and 40°C(76.9˚F-103.9˚F). • Essential oils are highly concentrated oils. Use with caution.