Advertisement
Quick Links
Advertisement
Summary of Contents for Lapcom s series
- Page 1 LAPCOM S SERIES GPS RECEIVER Instruction Manual PERCUL CORPORATION...
- Page 2 4. Power port Insert the power connector. 5. Communication cable ５ Connected to the COM port of Lapcom unit. 6. Battery snap Used for 9V square type battery. 7. Power connector Connect to 12V power or 9V square type battery on the other side, and insert to the power port of the GPS receiver.
- Page 3 * The power connector’s red line is into the plus(+) of the 12V power battery or 9v square battery, the black line is into the minus(-). * Available voltage is DC7.5V to DC14.5V. 3. Connect the communication cable to the Lapcom COM port. LAPCOM COM port...
- Page 4 Installation for kart Attach the GPS receiver’s top side with logo horizontally toward the sky on the front panel by two-sided tape or hook & loop fastener. Please provide the installation bracket as per your requirement. Installation for motorbike Attach the GPS receiver’s top side with logo horizontally toward the sky on the rear cowling by two-sided tape or hook &...
-
Page 5: Shift Key
Parameter setting of the Lapcom unit Set the communication speed between GPS receiver and Lapcom unit. 1. Verify that [READY] is displayed on the display screen. If [READY] is not displayed, press the CLEAR key to display it. 2. Press and hold the SHIFT key and MODE key at the same time for 3 seconds to change to the parameter setting screen. - Page 6 * Please refer to each model’s instruction manual for the parameter setting. * It is necessary to measure speed. 8. Insert a SD card into the Lapcom main unit, and confirm the SD card mark is shown on the display. LED and Display indication LED and the display indication of each status are as follows;...
-
Page 7: Cold Start
NOTICE POINTS COLD START: The first start after purchasing the GPS receiver, or the start after remaining unused for a long period. Please notice COLD START will take longer time to acquire the GPS satellite, like about 35 seconds. Turn on the power of the device 15-30 minutes before driviing in a open place to the sky.