Table of Contents
Advertisement
REPLACEMENT OF CHIP COMPONENT
! CAUTIONS
1. Avoid heating for more than 3 seconds.
2. Do not rub the electrodes and the resist parts of the pattern.
3. When removing a c hip part, melt the s older adequately.
4. Do not reuse a chip part after removing it.
! SOLDERING IRON
1. Use a high ins ulation s oldering iron with a thin pointed end of it.
2. A 30w s oldering iron is rec ommended for easily removing parts.
! REPLACEMENT STEPS
How to remove Chip parts
1.
# Resistors, capacitors, etc.
(1) As shown in the figure, push the part with tweezers and
alternately melt the solder at each end.
(2) Shift with tweezers and remove the chip part.
# Transistors, diodes, variable r esistor s, etc.
(1) Apply extra solder to each lead.
SOLD E R
(2) As shown in the figure, push the part with tweezers and
alternately melt the solder at each lead. Shift and remove
the chip part.
Note : After removing the part, remove remaining solder from
the pattern.
SOLD E R
2. How to install Chip parts
# Resistors, capacitors, etc.
(1) Apply solder to the pattern as indic ated in the figure.
(2) Grasp the chip part with tweez ers and place it on the
solder. Then heat and melt the solder at both ends of the
chip part.
# Transistors, diodes, variable r esistor s, etc.
(1) Apply solder to the pattern as indic ated in the figure.
(2) Grasp the chip part with tweez ers and place it on the
solder.
(3) First s older lead
A
(4) Then solder leads
A
No. 52056
AV-25BT6ENS
AV-25BT6ENB
A
as indicated in the figure.
B
C
B
C
and
.
B
C
7
Advertisement
Table of Contents
