Maragold DV Mark Owner's Manual page 5

13) PRESENCE The Presence knob (common for CH1 and CH2) controls high frequencies, above those controlled by the High knob on each
channel. It's an effective and useful part of the amp's tone controls. Turn the Presence up for crisp, sparkling clean sounds, crunchy rhythm
sounds and aggressive riffs; lower it for darker, rounder sounds and focused single-note lead tones.
14) LOOP ON/OFF LED This LED shows when the send/return loop is activated by the footswitch (20).
15) STANDBY Before powering on, make sure this switch is in standby position.
When you turn on the power, make sure this switch is in standby position for about 30 seconds. Between sets or whenever you're on a break
from playing, put the amp in standby position, this will extend the power tubes life.
16) POWER This switch delivers AC power to the amp. Make sure the unit is grounded; all three terminals of the AC power plug must be
connected to avoid any injury to the user or damage to the unit.
The DV Mark Maragold amp features Dual Voltage Switch 120V/240V to use the amp in countries with different voltages, so make sure the
switch on the rear panel is on the correct voltage before connect it to the AC power, and the fuse is the right value for that voltage. Follow the
procedure described in the STANDBY section above (15) before powering up your amp.
MARAGOLD
3 4 5
BASS MIDDLE HIGH
7
Ch2
Ch1
CH1
0 MAX 0 MAX
INPUT GAIN MASTER
1 2
6
22 23
13 9 10 11
BASS MIDDLE HIGH
0 MAX
STAND BY OFF
PRESENCE
CH2
0 MAX 0 MAX
GAIN MASTER
8
12
ON
15 16
LOOP ON
14
5