Your model is able to use LiPo batteries. LiPo batteries have a minimum safe discharge voltage threshold that should not be exceeded. The LaTrax Alias is equipped with built-in Low-Voltage Detection that alerts the pilot when LiPo batteries have reached their minimum voltage (discharge) threshold.
INTRODUCTION Thank you for purchasing the LaTrax Alias quad rotor high-performance helicopter. This manual contains all the necessary operating procedures that allow you to unlock the performance and potential that our engineers designed into your model. Even if you are an experienced R/C enthusiast, it’s important to read and follow the procedures in this manual.
• Fly 2-3 feet above the ground to avoid ground turbulence for a more stable and controllable flight. 1. Find a suitable flying area. Alias is approved for both indoor and outdoor flight. The recommended minimum area for indoor flight is 10 x 10 feet, with a ceiling height of 8 feet or more.
6. Fly the helicopter. Gently push the throttle stick forward to increase the RPM of the main rotors until the model begins to lift off. Reduce throttle to maintain a hover when the model is at least 2–3 feet off the ground. This height will keep the model away from ground turbulence for more stable flight.
Outdoor Flying Tips: • Choose a location that allows you to fly over grass or another soft surface. • Do not fly near power lines, trees, rooftops, or other obstacles. Do not retrieve the model from any location higher than your reach. •...
Page 7
LaTrax.com. ADVANCED FLIGHT: PERFORMING TRICKS In Expert 1 Mode (EXP1), Alias can perform automated expert tricks and flips when you press the AUX1 button, and then enter a quick stick command in the chosen direction. Do not attempt these flight tricks until you are able to fly confidently in Expert 1 Mode (EXP1).
WARNING! Do not store or attempt to charge a swollen or damaged battery! See LiPo Batteries section for more information. ROTOR BLADE INSTALLATION The Alias’ rotor blades are not identical. Each blade is labeled with an A or B. When installing Front...
Page 9
3. The accelerometer needs to be reset. Go to LaTrax.com for additional information and instructions or call the LaTrax Technical Support Line toll-free at: 1-888-872-9927. Visit LaTrax.com for more information on the advanced functions and additional features of your LaTrax Alias!
Need help?
Do you have a question about the 6608 and is the answer not in the manual?
Questions and answers