Advertisement
Important Notice
1.
Please make sure the voltage and frequency must comply with the rating label shown on the product.
2.
Never use the product on uneven surface. Never use it when there is an obstacle or an unstable surface.
3.
Do not fold, bend or pull the power cord to avoid bad contact of power connection.
4.
It must be properly installed before connecting the power cord to socket. Never connect power before full assemblage.
5.
Never use the product in humid, dusty, alkaline or acidic environment areas.
6.
Never insert finger or any object into the fan guard while in use.
7.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge. Unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not
play with the appliance.
8.
Do not expose infants and elderly to strong wind for a long time.
9.
When moving or maintaining the fan, please switch off the power and unplug. Never use wet hands to switch the power
off or unplug.
10. Should there be malfunction during operation, switch the power off then unplug immediately. Contract the supplier or
the maintenance centre for repair and maintenance.
11. If the power cord or plug is damaged, stop use immediately. It must be checked or repaired by the manufacturer or an
appointed maintenance centre.
12. Never disassemble or replace any parts of the product. In case of malfunction, please contact the manufacturer or the
maintenance centre for repair.
13. If the product is not in use for a long time, please switch the power off and unplug.
Name of Parts
1. Key
3. Display Cover
5. Bottom Front Plate
7. Front Base
9. Bottom Rear Plate
11. Fan Blower
13. Control Panel
15. Power Cord Holding Bracket 16. Base Screw
Assembling Method：
1. Assemble the front base and rear base, and the power cord through the center hole of the base. Then, secure the base
assembly to the fan body by inserting and tightening the screw to the bottom of the base. (Fig.2A).
2. Place the power cord securely in the power cord holding bracket then complete. (Fig.2B)
2. Front Plate
4. Front Grill
6. Power Cord
8. Back Base
10. Motor
12. Rear Plate
14. Body
Fig 2
Fig 1
Fig 1
Advertisement
