Auto Standby; Troubleshooting - Monster Rockin Roller 2 User Manual

AUTO STANDBY/ WAKE UP
Auto Stand by:
The Power Red LED Signal will turn on and other LED Signals will turn off once the main unit is in Standby
mode.
• Bluetooth: When there is no BT Connection, or there is a BT Connection failure, or if the BT
has been disconnected for 15 Minutes, the set will go to standby mode and the BT LED Signal
will turn off.
• AUX: The main unit will enter standby mode when the main unit is in AUX mode and no AUX cable
has been detected.
• Work Mode: When the main unit is in work mode, pressing and holding the volume knob key for 3
seconds will auto enter the unit to Standby Mode.
"Wake up" from standby mode:
If the main unit is in Standby mode, press and hold the volume knob for 1 second. The main unit will turn on and
return to the latest source mode. The Power Red LED Signal will turn off and the LED Screen will display the
latest source once the main unit is in work mode.

TROUBLESHOOTING

General
No power
• Check that the AC power cord is securely inserted in the unit and the electrical outlet.
• Check the Power On/Off switch is turn to On position.
• If battery is flat. Plug in the AC power cord to charge and operate. Keys no response
• Turn the Power On/Off switch to Off, and then On again to reset the unit.
• Unplug the AC power cord and plug it back again. No sound heard
• Make sure the Aux connected device volume is turn to reasonable level.
• Make sure the Bluetooth connected device output the audio thru BT out.
• Make sure the Bluetooth connected device volume is turn to reasonable level.
Bluetooth Operations
Audio quality is poor
• Bluetooth reception is poor. Move the Bluetooth device closer to the Speaker.
Cannot pair to Bluetooth device
• Make sure both Bluetooth device and Speaker is not connected to any other Bluetooth device.
• Make sure the Bluetooth On/Off switch located below Speaker is slide to On position.
• Make sure the Blue LED on the Speaker is fast flashing (Pairing mode).
• Turn Power switch to Off, and then On again. Press and hold BT button for 2 seconds to enter into pairing
mode.
9