Specifications; Installation; Location; Mounting The Radio - Connex 4600 TURBO Owner's Manual

TRANSMITTER
RF Power Output
AM/FM: SOW
Spurious Emission
-50dB
Audio Distortion
10%
Fre°uency Response
300 to 2500Hz
Microphone Dynamic
RECEIVER
Sensitivity
AM 0.5 uV for 10dB S+N/N
FM 0.25 uV for 12dB S+N/N
S°uelch Sensitivity 0.5uV
Selectivity
-50dB
Image Rejection
-50dB
Hum & Noise
40dB
Audio Output Power 2.5W at 10%THD
(SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE)
SPECIFICATION
INSTALLATION
GENERAL
Model
Frequency Range
Modes
Frequency Control
Frequency Stability
Temperature Range
Input Voltage
Antenna Impedance
Size
CX-4600TURBO
28.015 28.585 MHz
AM/FM
Phase-Locked-Loop Synthesizer
0.001%
0°C to +50 CC
DC 13.8V
50 Ohms
7 7/8"(W) x 10 3/4"(D) x 2 3/8"(H)
LOCATION
Plan the location of the transceiver and microphone bracket before starting
the installation. Select a location that is convenient for operation and does
not interfere with the drive or passengers in the automobiles, the transceiver
is usually mounted the dash panel with the microphone bracket beside it.
MOUNTING THE RADIO
The transceiver is supplied with a universal mounting bracket. When
mounting the bracket and radio to your car, make sure it is mechanically
strong. Also provide a good electrical connection to the chassis of the
vehicle. Proceed as follows to mount the transceiver:
Weight
5.Olbs
1. After you have determined the most convenient location in your vehicle,
hold the transceiver with mounting bracket in the exact location desired.
If nothing will interfere with mounting it in the desired position remove
the mounting bolts. Before drilling the holes, make sure nothing will
interfere with the installation of the mounting bolts.
2. Connect the antenna cable plug to the standard receptacle on the rear
panel. Most transceiver antennas are terminated with a type PL-259 plug
and mate with the receptacle.
3. Connect the red DC power input wire (with the fuse) to +13.8V DC.
This wire extends from the rear panel. In automobile installation,
+13.8V DC is usually obtained from the accessory contact on the
ignition switch. This prevent the set being left on accidentally when the
driver leaves the car and also permits operating the unit without the
engine running. Locate the accessory contact on most ignition switches
by tracing the power wire from the AM broadcast receiver in the car.
4. Connect the black lead to -13.8V DC. This is usually the chassis of the
car. Any convenient location with good electrical contact (remove paint)
may be used.
5. Mount the microphone bracket on the right side of the transceiver, using
two screws supplied. When mounting in an automobile, place the
bracket under the dash so that microphone is readily accessible.