Advertisement
Operating Instructions
【Battery Installation】
●
Turn the battery cover
down ； insert one battery
correctly
(note the negative electrodes face down) insert and turn
the cover back into position. Turn the viewer on, the
screen will light up if the battery is installed correctly.
Otherwise, please reinstall the battery again or tighten the
cover again.
【Announcements】
Ensure the model of battery is correct;
Ensure the electric Volts and Amps match;
Pay attention to the anode and the cathode of the
battery.
Operating Instructions
【Scenery Observation】
●
Take the objective cover down, observing the
screen from eyecup #11.
1.
Adjust the diopter ring #10 until to get the sharp
images
2.
Adjust the objective focusing wheel #2 to make the
images to be sharpest and easy to observe then.
●
Automatic fine-tuning control of display brightness
could be operated by Viewer.
●
Digital zoom could be realized by pressing #13
and #14 ranged at 1x to 8x.
●
If the environment is light enough, turn the
auxiliary light off to save the power. On the
contrary, please turn the auxiliary light on to get
the sharpest image to observe
●
Otherwise, please turn the auxiliary light on.
【Announcements】
Don't block the light resource.
PSHTCM88
Operating Instructions
【Power On】
●
●
●
●
【Power Off】
●
7
PSHTCM88
Operating Instructions
【Brightness Adjustment】
press #16.
brightness adjustment. Just as the
screen showed, the number after
"Bright"
brightness index.
it. 9 means the highest brightness of display. The index
ranged at 1 to 9, 9 means the brightest index.
【High Beam Adjustment】
In the observing mode, press
#16 twice to enter the high beam
adjustment menu.
The screen will be just as the
picture showed.
The index of LAMP shows the
intensity of auxiliary light.
9
Take the objective
cover down.
Long press #19 for
3 seconds to light
screen up， observing
from Eyecup #11， if
the screen is lit up and icons have been shown
normally, the viewer could be used then
Icons Instructions：
1
Battery
2
Images Size
3
Current Mode: Photo Shooting Mode
4
Internal Memory Check
The Observing (Photo Shooting) Mode is available
to use after the startup.
In any mode, long press #17 for 3 seconds to turn
it off.
In the observing mode,
Enter
the
menu
of
means
the
current
Press #15 to heighten the index and #16 to lower
PSHTCM88
1
2
3
4
0 3 7 2 7
SD
8
PSHTCM88
*
Br i ght : 7
LAM P 0
SD
Brightness Adjustment
Br i ght : 7
*
PO W LED 0
LED :
O FF
0 3 7 2 7
SD
High Beam Adjustment
10
Advertisement
