Advertisement
RE10RF 009 Quark9_Layout 1 10.02.2015 11:40 Strona 2
Box Contents
Product Compliance & Safety Info
• Electro-Magnetic Compatibility directive
2004 / 108 / EC
• Low voltage Directive 2006/95/EC
These instructions are applicable
to the SALUS model stated on this
1 x Installer / User manual
instruction guide.
This product must be fitted by a competent
person, and installation must comply with the
guidance, standards and regulations applicable
to the city, country or state where the product is
installed. Failure to comply with the requirements
1 x RE10RF
of the relevant guidance, standards and
regulations could lead to injury, death or
prosecution.
Always isolate the AC Mains supply before
1 x EU Plug Adapter
installing or working on any components that
require 230 VAC 50Hz supply.
For PDF Installation guide go to
We hope you enjoy this product...
www.salus-controls.com
INSTALLATION
1
Plug
Plug the repeater
2
into the adaptor.
Plug in the coordinator as
3
described in the Coordinator
Instruction Manual. All device
pairing is done through the
coordinator.
SYSTEM OVERVIEW
Product Compliance
INTRODUCTION
If your iT600 system has more than 32 battery-powered devices, alongside
the CO10RF ZigBee coordinator you must add an RE10RF ZigBee repeater.
You must also add an RE10RF repeater if the battery-powered devices in
your iT600 system are too far away from the mains-powered devices.
Warning
Warning
Press and hold the button on
4
the Coordinator for five seconds
to enter pairing mode. The LED
flashes red.
Repeater
Plug the repeater into the
5
mains power. The button
flashes red.
Refer to individual device
manuals for more information.
SALUS Wiring Centre
KL10RF or KL08RF
RE10RF
RX10RF
Press and release the repeater
6
button. The LED goes solid red
to show it is connected to the
network.
The system installation is now
7
complete. Press and hold the
button on the Coordinator for
five seconds to close pairing
mode. The LED goes solid red.
Also refer to the coordinator
and individual device manuals.
INSTALLATION
The ZigBee repeater must be used with
the iT600 RF range of products below:
iT600 System
VS10/20RF
Thermostat
CO10RF
TRV10RF
TRV10RFM
Advertisement
