Table of Contents
Advertisement
Bolt (A)
Front hole (B)
Front hole (C)
Nut (F)
Clutch
Clutch cover
Guide bar adjuster hole
CS-620P
PREPARATION FOR USE
Dimple (D)
®
Kick Guard
Recess (E)
Guide bar
Unlock chain brake
Brake lever
(Front hand guard)
Spiked bumpers
Two nuts
Clutch cover
Guide bar studs
Nuts
Saw chain is sharp! Always wear gloves
when handling assembly, otherwise serious
personal injury may result.
KICK GUARD
INSTRUCTIONS
Tools Needed: Two 11 mm (7/16 in.) Wrenches.
For saws with Kick Guard
Symmetrical Low-Kick type (Double Guard)
guide bars.
1. Install bolt (A) in front hole (B) of Kick Guard
and through front hole (C) in guide bar.
2. IMPORTANT: Dimple (D) in Kick Guard
engage recess (E) in guide bar.
3. Tighten nut (F) and bolt (A) using 11 mm (7/16
in.) wrenches until snug. Make certain Kick
®
Guard
is flush against guide bar.
4. Tighten nut (F) 1/8 additional turn.
5. Check to make certain Kick Guard
guide bar.
GUIDE BAR AND SAW CHAIN
INSTALLATION/REMOVAL
1. Remove spark plug lead. (See page 26)
2. Remove two clutch cover nuts and remove
clutch cover.
3. Remove bar and saw chain if necessary. See
"Maintenance and Care" section for guide bar/
saw chain maintenance procedures.
4. Unlock the chain brake, and mount guide bar on
studs and slide toward clutch to make saw chain
installation easier. Install chain with cutters on
top of guide bar facing forward.
5. Install the clutch cover over the guide bar studs.
Ensure chain tension adjuster pin fits into the
guide bar adjuster hole. Tighten clutch cover
nuts finger tight.
10
WARNING
®
TO BAR
®
P/N 2893201 and
®
®
is tight on
®
must
Advertisement
Table of Contents
