Salt Dogg WB400 Assembly Instructions

WB400
Walk Behind Drop Salt Spreader
Check contents of box against the parts list to
make sure all components are included. When
ordering replacement or spare parts refer to the
parts list for part numbers.
Tools Needed for Assembly
(2) 3/8" Wrenches
(2) 1/2" Wrenches
(1) 3/32" Allen Key

Operating Instructions:

Before filling Hopper, ensure that the Restrictor
1.
Plate is fully closed and the screen is in place.
Move and tighten the CAM to the desired
2.
setting. See fig 4.
Begin moving forward with the spreader.
3.
Adjust flow as needed with lever.
4.
5. Before stopping, close flow gate.
Maintenance:
The Hopper and Spinner should be completely
1.
emptied and cleaned before storage.
The Spreader should be washed and dried
2.
before storage.
Check that the Restrictor Plate and Linkage
3.
move freely. Clear out any debris between the
Restrictor Plate & the Hopper.
Check torque of all fasteners on a monthly basis.
4.
TM
Assembly Instructions
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • saltdogg.com
Operation Note:
The Spreader is designed to be operated at
1.
a brisk walking pace (approx. 3 mph). Walking
slower or faster will alter the distribution pattern
& amount of the material, as will the moisture
content of the material & other environmental
factors.
WARNING
When filling hopper, make certain there are no large
objects within the material. Objects larger than the
openings in the Screen may cause the spreader to
clog or even damage the drive system. Never leave
material in the hopper when not in use.
9049 Tyler Blvd. • Mentor, Ohio 44060