Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Brice TJ
- Page 1 ™ Operation and Safety Manual Model TJ/TS Mincer Range...
-
Page 2: Safety Issues
SAFETY ISSUES 1. NEVER touch this machine without training and authorisation from your supervisor. 2. Machine MUST BE on solid, level support. 3. Guards MUST BE in place before plugging in and turning on machine. 4. ALWAYS use the three-pronged power plug provided. 5. - Page 3 Overview Introduction This Operation and Safety Manual has been prepared to introduce you to the Brice Model TJ/TS Mincers. It explains the operation, cleaning and maintenance of the mincers in simple, clear terms and with an emphasis on your safety.
- Page 4 THE MINCER BEING ACCIDENTLY TURNED ON DURING CLEANING OR MAINTENANCE. Mincers are very powerful machines that can easily cause severe crush injuries if mishandled. WHENEVER YOU USE THE MINCER YOU MUST NEVER PLACE YOUR HAND INSIDE THE THROAT OF THE MACHINE. Model TJ/TS Mincer 1.2 Introduction...
- Page 5 Operation and Safety Manual ™ The Model TJ/TS Mincer range is built for high volumes and hard work. They are The Brice Model elec tron i cal ly controlled, fast, clean and effi cient. • Manufactured in stainless steel and anodised aluminium to resist the corrosive effects TJ/TS Mincer of salts and acids;...
- Page 6 This will remove any traces of machine oil, dirt or grit picked up during manufacture or storage. Before you wipe down the machine, make sure that the power is turned off. Model TJ/TS Mincer 1.4 Introduction...
-
Page 7: Operation
6. Open up the mincer often and remove all bones, gristle and other foreign matter ac- cumulated in the center of the plate and knife. Model TJ/TS Mincer Operation 2.1... - Page 8 If, however, one is matched with a different member which is ground true, the set will not cut cleanly. In addition, there is the very real chance of breaking one or both parts of the set. Model TJ/TS Mincer 2.2 Operation...
-
Page 9: General Cleaning
This section deals with cleaning your mincer, including knife and plate set care. Cleaning the We recommend that, before cleaning or maintenance tasks are undertaken, the machine operator(s) receive some training from authorised Brice representatives, preferably during Mincer the installation phase. -
Page 10: Troubleshooting
Mincer is switched OFF at the isolating switch. Routine Maintenance The robust design of the TJ and TS Mincers means that there is very little required in the way of routine maintenance. Generally, the only maintenance required is cleaning (discussed in the previous section) and changing of the knife and plate sets. -
Page 11: Copyright Information
This document may not be reproduced, in whole or in part, by any means without the prior express written permission of the copyright owner. Brice and the BRICE logotype are trademarks of Brice Australia Pty. Ltd. Printed in Australia 23067/TJTS_man_pdf...