Ring Powering RINV500 PowerSource User Manual

Specifications
PowerSource Model
Max. Continuous power (Watts)
Peak Power (Watts) 0.01 Seconds
No load current draw (AMPS)
Waveform
Cable length
Cable diameter
Efficiency*
Input Voltage Range
AC Socket
Fuse
Weight (kgs)**
Dimensions (mm)
* Percentage of battery power converted to mains voltage power.
Troubleshooting Guide
Symptom Possible causes
AC appliance will not operate; 1. Battery has discharged to 10v.
the audible alarm is sounding.
2. The inverter has overheated. This
could be due to poor ventilation.
3. Poor battery condition
AC appliance will not operate; 1. Inverter is overloaded.
the audible alarm is not
sounding. 2. Internal fuses have blown
Run time is less than expected 1. Battery is not fully charged
2. AC appliance power
consumption is higher than
expected.
For further assistance: Technical Helpline: +44 (0)113 276 7244
CE and e approved.
Distributed by:
Ring Automotive Gelderd Road, Leeds LS12 6NB
Tel: +44 (0)113 276 7676 Fax: +44 (0)113 231 0266
Email: autosales@ring.ltd.uk
RINV500
500w (1/2 hour) 400w (4hrs)
800w
<0.2A
Modified Sine
1m
7mm
Approximately 90%
10 – 15v DC
3 Pin Mains (BS Approved)
35 amps (x2)
1.5
230 x 107 x 60
** Does not include packaging
Possible solution
Turn off the inverter on/off switch
and recharge the battery.
Turn off the inverter and allow to
cool for 10 mins.
Replace battery.
Reduce load, not exceeding
maximum rating.
Fuse replacement (qualified
electrician only)
Recharge the battery.
Check AC appliance wattage
rating is within scope of inverter.
4
PowerSource
Mains powered equipment from a 12v source
12v DC to 230-240v AC Power Source
L209
User Manual
500 Watts
Model RINV500