Connecting The Antenna; Testing The Connections - Optimus 12-2110 Owner's Manual

12-2110.fm Page 9 Wednesday, July 14, 1999 11:19 AM
Follow these steps to connect the
wire harness to the speakers.
1. Connect the gray wire to the
right speaker's positive termi-
nal. This terminal is usually
marked with a plus (+) sign or
red mark.
2. Connect the gray/black wire to
the right speaker's negative ter-
minal. This terminal might be
marked with a minus (
it might not be marked at all.
3. Connect the white wire to the left
speaker's positive terminal.
4. Connect the white/black wire to
the left speaker's negative termi-
nal.

Connecting the Antenna

Connect the vehicle's antenna cable
to the stereo's large, black antenna
jack.

Testing the Connections

Caution: Make sure you have se-
curely made all connections before
continuing with the installation.
Plug the 14-pin connector into the
14-pin wiring socket, then reconnect
the cable to the vehicle battery's neg-
ative terminal.
Turn on your vehicle's ignition and
test the stereo.
If the stereo does not work, turn off
your vehicle's ignition, then imme-
diately disconnect the 14-pin con-
–
) sign or nector from the stereo's 14-pin
wiring socket, and the cable from
your vehicle battery's negative (
terminal. Then recheck your con-
nections.
After you verify that everything
works, make sure the connections
are correctly marked or identified.
Then
"Mounting the Stereo" on Page 10.
follow the instructions
–
)
in
9