Preparation And Watching Tv; Turning On/Off The Power; Changing Channels; Standby Mode - Sharp Aquos LC-32LD171K Operation Manual

Using the remote control
Use the remote control unit by pointing it towards the
remote control sensor� Objects between the remote
control unit and sensor may block proper operation�
Remote control sensor
• If you are not going to use the remote control for a long
time, remove the batteries to avoid damaging remote
control caused by chemical leakage�
Display the Menu Screen
Press MENU on the remote control to display the
menu screen�

Select an item by the remote control

Main Menu
Picture
Smart Picture
Backlight
Picture
Contrast
Sound
Brightness
Saturation
TV
Sharpness
Tint
Setup
Colour Temperature
16:9 Overscan
Parental
Advanced Video
Select EXIT RETURN
3
1�
Press to select the desired menu�
2�
Press to select / adjust the item to the desired
level� The new setting on the screen is applied
immediately�
3�
Press EXIT to return to the previous layer�
Exit the Menu Screen
Press EXIT or Menu to exit the menu screen�
Run the auto installation
Follow the onscreen instructions to select your
preferred Language, Country, and Location�
(7 m)
30º (5 m)
0º
Horizontal
1/2
Standard
32" 40" 50"
75 58 68
90
50
50
10
0
Normal
On
OK Access

Preparation and Watching TV

Daily operation

Turning on/off the power

Turn on the power by pressing the
Turn off the power by pressing again the
the TV�

Changing channels

Change channels by pressing P

Standby mode

To standby mode
E
If the TV set is switched on, you can switch it to
standby mode by pressing B button on the remote
control�
Switching on from standby
E
To switch on from standby mode, press B button on
the remote control�
TV indicator status
B indicator
Off
Red
Blue
NOTE
• If you are not going to use this TV for a long period of
time, be sure to remove the AC cord from the power
outlet�
• A small amount of electric power is still consumed even
when the power is turned off�

Selecting external video source

Once the connection is done, press b button to
display the Input Selection screen, and then press
button to switch over to the appropriate external
source, and press with OK button to confirm�
button on the TV�
button on
button�
Status
Power off
Standby
Power on
- 5