Shutting Down - Sun joe SPX1000 Operator's Manual

4. Unlock the safety lock, then press the trigger for a few
seconds until the water flow is steady. Operating the
pressure washer in this manner will allow air to escape
and discharge residual pressure in the hose (Fig. 14).
Fig. 14
Push to release
high-pressure hose
5. Keeping the trigger pressed, turn the switch to the ON (I)
position to start the pressure washer.
6. When re-starting the motor, always keep the trigger
pressed.
NOTE: The motor only runs when the trigger is depressed
and shuts off when the trigger is released.
Using the adjustable spray wand
m
WARNING!
High-pressure jets can be dangerous if
subject to misuse. The jet must not be directed at persons,
pets, live electrical equipment, or the appliance itself.
1. The washer is equipped with an adjustable nozzle.
2. The water pressure can be adjusted from low pressure (–)
to high pressure (+) by turning the pressure adjustment
knob. The nozzle tip can be adjusted from pencil spray
(wide open tip) to fan spray (narrow tip) by turning the
nozzle tip adjustment knob (Fig. 15).
Pressure adjustment knob
Pencil spray
Nozzle tip
Nozzle tip
adjustment knob
Fig. 15
m
WARNING!
Do not adjust the nozzle while the trigger
is squeezed. Failure to do so could result in damage.
RELEASE
Trigger
Safety lock
Fan spray
Recommended cleaning procedure
1. For additional cleaning power, a detergent spray
bottle attachment (Model SPX1DT) is available as an
add-on accessory for the SPX1000. Visit snowjoe.com
to purchase.
m
CAUTION!
Only use detergents specifically
recommended for use with pressure washers
2. Load the bottle with a suitable, non-corrosive detergent
and attach it the spray gun (Fig. 16).
Fig. 16
Detergent spray bottle
3. With the nozzle tip adjusted to a low-pressure fan spray,
apply detergent from the bottom to the top of the dry
surface to be cleaned. Applying detergent in this manner
will dissolve dirt most effectively.
NOTE: Wetting the surface first is not recommended as it
dilutes the detergent and reduces its cleaning ability.
4. Allow the detergent to remain on the surface for a short
time before rinsing with the pressure washer. Do not allow
the detergent to dry on the surface.

Shutting down

1. Turn the switch to the OFF (0) position and unplug the
power cord from the outlet.
2. Turn off the water source.
3. Hold the trigger to release water pressure.
4. Disconnect the garden hose from the water inlet on
the unit.
5. Disconnect the high-pressure hose connection on the
trigger gun handle.
6. Release the trigger and engage the gun safety lock.
m
WARNING!
Turn off the water supply and squeeze the
trigger to depressurize the unit. Failure to do so could result in
personal injury due to discharge of high-pressure water.
10
(Model SPX1DT)