Operation - Ortech OD-100G Instruction Manual

15A/125V
4. If there's no
WARNING
Do not attempt to wire you own new outlets or circuits. To reduce the risk of fire, electric shock
or injury to persons, always use a licensed electrician.
5. Make sure the fireplace insert is switched off (refer to operation instruction section).
6. Plug the fireplace into a 15A/125V socket. Wiring the cord along the corner of wall.
Control the Electric Fireplace
A. Buttons and indicators
There are four buttons on the remote controller, and four on the control panel of
the fireplace; each pair of buttons performs the same function:
<I/O> button is main power switch, located near the power cord.
<ON/OFF> button is power switch of the electric fireplace;
<DIMMER> button is used to adjust the brightness of simulated flame and logs;
<LOW> button turns the heater on and switches it to low-power status. If the heater is already on,
depressing this button will turn it off
<HIGH> button turns the heater on and switches it to high-power status. If the heater is already on
depressing this button will turn it off
is the power indicator, it lights up when
the fireplace is working, and turns off
when the fireplace is off
indicates the status of the simulated
flame and logs. It's brightens up when
the flame component is working, and will
flash as the brightness of the flame is
adjusted;
indicates the heater is working in low-
power status;
indicates the heater is working in high-
power status.
The red window on the control panel of fireplace is the eye of receiver, do not cover.
B. Operation
Install the batteries of the remote control Slide the cover in the direction of the arrow. Install two AAA
batteries according to the marks in the box, and slide the cover to its original position.
To use the remote controller effectively, point it to the electric fireplace and keep a distance of 1-5 meters.
1. Power control. Press the <ON/OFF> button, the electric fireplace will be powered on, and the
lamp illuminate. The heater will not be turned on automatically when you power on the fireplace,
please refer to paragraph 3. Note, all operations are valid only when the power is on, except to
"turn the power on" operation. Press the <ON/OFF> button again, the fireplace will be powered off.
2. To adjust the brightness of simulated flame and logs: When the fireplace is powered on the flame
is turned on automatically. Press <DIMMER> button to adjust the brightness, the
flashing, and the brightness of the flame and logs will start and keep changing. When the
brightness goes to the point you want, press <DIMMER> button again, and the brightness will
keep still and the
3. Heater control. Lamp
when is illuminated, in high-power status when
www.ortechindustries.com
outlet near the desired location, install a new one near or behind mantel.
lamp will brighten up.
and indicates the status of heater. It's working in low-power status
is illuminated, and is turned off when both of
5
lamp will be