Metronome Volume; Local Control; Auto Power Off; Audio Input - Kurzweil Andante CUP2A User Manual

Metronome Volume

This setting ranges from 1 (lowest) to 9 (loudest). The default setting is 9 . In Settings Mode , press
the Prev- or Next+ button to reach the desired volume level. The Metronome setting is remembered
across power cycles.

Local Control

When you play the CUP2A keyboard you hear the resident or"local" voices, because this parameter
is normally set to On . When using your CUP2A with an external sequencer or computer, turn this
setting to Off to avoid creating a MIDI loop which may result in stuck notes or"echoes" . Press either
the Prev- or Next+ button to set this parameter.

Auto Power Off

This energy-saving feature will automatically shut off power to the unit after a period of inactivity.
Simply turning the power switch off and on will power up the unit once again. This allows you to
reduce overall power consumption, and also extends the lifetime of the instrument. Press the Settings
button until the display reads AutoPowerOff. Options are Disabled, 15 min, 30 min, 1 hour, 2 hours
or 4 hours . The default value is 30 min . Pressing the Prev- / Next+ button pair will reset to default.

Audio Input

This parameter enables or disables the audio input jack. In some situations, the user playing the
CUP2A may notice a high frequency noise when not using the Audio Input (that is, with no signal
applied to the input jacks). Setting Audio Input to Disabled will overcome this. The default setting is
Enabled . The audio input setting is remembered across power cycles.

Hard Reset (Restoring Factory Defaults)

This function resets the Andante CUP2A to the original factory default settings. All user changes,
saved Favorites, and user recorded songs are erased. This action cannot be undone.
1. Press the Settings button until the display reads HARD RESET
2. To perform the Hard Reset function press the Next+ button once.
3. The display now reads CONFIRM
4. Press the Next+ button again confirm and to reset the CUP2A. The unit will then erase its user
memory, restore all factory settings and reboot.
If you want to cancel the Hard Reset and remain in Settings Mode , press the Prev- button to confirm.
Press any other button to exit Settings Mode .
There is an alternate method for a Hard Reset on your Andante CUP2A:
1. Hold the C8 key down while switching on the power.
2. Continue to hold C8 down until you see"RESETTING" (scrolling) in the display then release.

OS/Objects Version

T o check for possible updates to your operating system in Settings Mode press the Settings button until
"OS " is displayed. This will display the current operating software and objects version.
The display first shows the OS version, then the Object version. Visit the Kurzweil website (www.kurzweil.
com) to verify that your CUP2A has the latest versions. These are located under the Downloads tab for the
CUP2A. Complete installation instructions are included in the downloaded files. A standard USB cable will
be required for this operation.
.
?
?
43 19
Settings Mode