Advertisement
Visuality™
Mobile Video Awareness System
Quick Start Guide
The compliance information in this document is incomplete and subject to change.
IMPORTANT
Part Number: 07MVISMVAS-QS, Rev. B
Revised: March 1, 2012
Sales Office: +1 (301) 975-1000
Technical Support: +1 (301) 975-1007
E-mail: support@patton.com
WWW: www.patton.com
Advertisement
Table of Contents
Summary of Contents for Patton Visuality
- Page 1 Visuality™ Mobile Video Awareness System Quick Start Guide The compliance information in this document is incomplete and subject to change. IMPORTANT Sales Office: +1 (301) 975-1000 Part Number: 07MVISMVAS-QS, Rev. B Technical Support: +1 (301) 975-1007 E-mail: support@patton.com Revised: March 1, 2012...
- Page 2 1.0 Install the chassis for the T7900 The T7900 is a CompactPCI blade that is housed in a Patton Model 6286 2U chassis. The Model 6286 Mid-plane & Chassis can be easily configured according to your system requirements. Due to the broad application possibil- ities, the following checklist is provided as a quick set-up guideline.
- Page 3 To avoid the risk of injury from electric shock, the power cords connected to the IEC-320 connectors must be grounded power cords. WARNING Rotate the power cable retainer clip (see figure 1) so it secures the power cable plug in the IEC-320 connector. Visuality™ MVAS Quick Start Guide...
-
Page 4: Installing The Power Cables-Dc Unit
Repeat the procedure for the negative lead, using the “-DC input” of the terminal block. Make sure that there is no exposed wire. DC connector, -DC and +DC input view Figure 2. Repeat steps 1 through 3 to install the remaining DC power connection. Visuality™ MVAS Quick Start Guide... - Page 5 C.onnect the Console port–Use a serial cable to connect the Console port to an open serial port on a PC. 4.0 Install the remote T771x units Refer to the Visuality™ MVAS Deployment Guide , and the T771x model’s User Manual and Quick Start Note 6.0 “Addi-...
-
Page 6: Additional Information
To configure the T7900 using the CLI, connect a PC to the unit’s console port. Open a terminal program on the PC and create a connection with the default settings: 19200 baud rate, 8 data bits, no parity, and 1 stop bit. For information on configuring the T7900, refer to the Visuality™ MVAS Deployment Guide and the Note TrinityAE Adiminstrator’s Reference Guide, available online at www.patton.com/manuals/Visuality.pdf. -
Page 7: Copyright Statement
Trademarks statement The term Visuality is a trademark of Patton Electronics Company. All other trademarks presented in this document are the property of their respective owners. Patton support headquarters in the USA Online support: Available at www.patton.com... - Page 8 NOTES ____________________________________________________________________ ____________________________________________________________________ ____________________________________________________________________ ____________________________________________________________________ ____________________________________________________________________ ____________________________________________________________________ ____________________________________________________________________ ____________________________________________________________________ ____________________________________________________________________ ____________________________________________________________________ ____________________________________________________________________ ____________________________________________________________________ ____________________________________________________________________ ____________________________________________________________________ ____________________________________________________________________ ____________________________________________________________________ Visuality™ MVAS Quick Start Guide...