Advertisement

Quick Links

OMEGA

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CR-2000 OMEGA and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for FineDigital CR-2000 OMEGA

  • Page 1 OMEGA...
  • Page 2 Copyright and Trademark No part of this document can be copied or reproduced in any form without written consent from FINEDIGITAL Inc.. Finevu is a trademark of FINEDIGITAL Inc. and may not be used without the express permission of FINEDIGITAL Inc.. All trade names and trademarks are the properties of FINEDIGITAL Inc..
  • Page 3: Table Of Contents

    Contents Display configuration ......15 Warning ............4 Safety Switch to Live View (Driving mode) ..15 Caution ............5 Instructions Recording while driving .......16 Features ............6 Using the Video recording while parking ..17 product Components - Front ........ 7 Main Menu ..........18 Components - Rear ........
  • Page 4: Warning

    Safety Instructions WARNING Breaching the following precautions may result in serious personal injury or even death. Power • • Do not use a damaged or modified power cable. Failure to do Do not allow the product to come into contact with flammable so may cause explosion or fire, leading to personal injury or and explosive liquids or gases.
  • Page 5: Caution

    Changing camera composition may result in an after-image on without prior written consent from FINEDIGITAL Inc. the LCD monitor. • FINEDIGITAL Inc. is not liable for any data loss or damage to the product due to a car accident or product failure which can occur in any circumstance.
  • Page 6: Features

    Features Clear video quality Super capacitor used • • 16:9 wide screen and HD high quality video recording When the power is suddenly down due to accidents, • 1920x1080 effective pixel and SONY CMOS SENSOR the video file being recorded can be safely stored by (Full HD @ 30fps at both front and rear) emergency power.
  • Page 7: Components - Front

    Components and names Double-sided tape for the Mount installation of the front mount GPS (optional) Cable clips Polarized filter (optional) Front camera Continuous power cable The components of this product are subject to change without notice in order to improve its performance.
  • Page 8: Components - Rear

    Components and names Components - Rear Double-sided tape for the installation of the rear mount Rear camera Rear camera cable Components - PC connection USB SD card reader (optional) micro SDHC card adapter micro SDHC card The components of this product are subject to change without notice in order to improve its performance.
  • Page 9: Accessories

    CR-2000 OMEGA User Manual Accessories USB SD card reader Polarizing filter Note All accessories are available from the store where you purchased the product.
  • Page 10: Part Names - Front Camera

    Components and names Part names - Front camera Mount connection area Power port This is where the mounting Connects to the power supply bracket is combined. (DC 12V). GPS connection port Cooling vents This port is used for connecting Dissipates heat generated by to the GPS.
  • Page 11: Part Names - Rear Camera

    CR-2000 OMEGA User Manual Part names - Rear camera Attachment type holder Fix the camera location. Rear camera lens Record videos from the rear. Rear connection port This port is used for connecting Security LED to the front camera. Check operation of the Dash Camera.
  • Page 12: Selecting The Installation Location For A Front Camera

    Installation Selecting the installation location for a front camera Inserting the micro SDHC card • You are recommended to install the product on the front windshield, to the left or right of the room mirror. Insert the SDHC card Selecting the installation location for a rear camera •...
  • Page 13: Installation - Front

    CR-2000 OMEGA User Manual Installation - Front Attach the Dash Camera Install the mounting to the mount. bracket in the vehicle using the double-sided tape. Use a clip to fix the power Plug the continuous cables. power cable into its socket.
  • Page 14: Installation - Rear

    Installation Installation - Rear Install the mount on the rear windshield of the vehicle using the Adjust the rear view camera double- angle. sided tape. Connect the rear camera cable to the front view camera. Connect the rear camera cable to the front camera. Use a clip to fix the rear camera cable.
  • Page 15: Using The Product

    Using the product Display configuration Live view Main Menu Emergency recording Main Menu Microphone on/off Live view • You can choose the one among Front / Rear / Dual / Standby view when the system boots. Switch to Live View (Driving mode) Front view Rear view Dual view...
  • Page 16: Recording While Driving

    Using the product Recording while driving • Normal Recording: When booting is complete, the Normal Recording mode starts. Recorded video files are saved in the 'normal' folder of the memory card (micro SDHC card in case of dual SDHC card). •...
  • Page 17: Video Recording While Parking

    CR-2000 OMEGA User Manual Video recording while parking • Parking Mode: When turning off of the vehicle (ACC power cut-off), the system switches to Parking mode. When turning on of the vehicle (ACC power on), the system switches to the Normal recording mode.
  • Page 18: Main Menu

    Using the product Main Menu • Press the Menu button to go to the Main Menu page. • If you go to the Main Menu page in the Normal Recording mode, video recording will pause. • It is dangerous to operate Main Menu while driving. Always stop the car before you do it. •...
  • Page 19 CR-2000 OMEGA User Manual Front Rear You can change the front view You can change the rear view camera settings. camera settings. Memory You can change or format memory settings. Info. You can view the current settings. Live view Goes back to the shooting mode, where you can view videos.
  • Page 20 Using the product Front (Rear) Resolution Frame You can change the Driving You can change the frame mode resolution settings. settings. Save Brightness/WDR You can save the changed You can adjust the brightness setting values. and WDR of videos. Cancel Resolution Back to the Main Menu page.
  • Page 21 CR-2000 OMEGA User Manual Brightness / WDR Sharpness Brightness You can adjust the sharpness You can adjust the brightness of images. of videos. Night Brightbess You can adjust the brightness of videos at night. Shooting Mode Wide Dynamic Range (WDR)
  • Page 22 Using the product Memory - In case of installing only the micro SDHC card Go to Main Menu ► Memory to change the settings. Format the SDHC Card – Formats the memory card that is highlighted. • If only the micro SDHC card is installed: - Videos recorded in both Driving and Event modes are all stored in the micro SDHC card.
  • Page 23 CR-2000 OMEGA User Manual Memory - In case of installing both the micro SDHC card and the SDHC card Go to Main Menu ► Memory to change the settings. Format the SDHC Card – Formats the memory card that is highlighted.
  • Page 24 Using the product Memory The range and the storage folder of the video recorded in each recording mode are as follows: Mode Time saved Storage folder name Resolution 1080p / 900p / 720p Normal recording normal 2 minutes in total From 10 seconds before to 10 seconds after event detection Event detection recording event...
  • Page 25 CR-2000 OMEGA User Manual System ADAS Low voltage block You can configure LDWS, FCWS You can change a cut-off and FVMA functions. voltage and timer settings. Speaker You can adjust the volume of the speaker. Sensitivity Time setting Display You can configure the sensitivity...
  • Page 26 Using the product ADAS Go to Main Menu ► System ► ADAS to change the settings. • LDWS : 60km/h, 80km/h, 100km/h, OFF • FCWS : 30km/h, 60km/h, 90km/h, OFF • FVMA : ON/OFF • Alarm : Beep sound • Vehicle : Sedan, SUV, Truck When the lane departure is detected, a warning sound will occur(LDWS).
  • Page 27 CR-2000 OMEGA User Manual Low voltage block Go to Main Menu ► System ► Low voltage block to change the settings. • You can change a cut-off voltage and timer settings. Sensitivity Go to Main Menu ► System ► Sensitivity to change the settings.
  • Page 28 Using the product Play Select Main Menu ► Play to view videos. • Three images of video files are displayed. Select a video you want to view by clicking the image. Click again to play the video. Press this button to view the next 3 video clips. Press this button to jump 9 video clips.
  • Page 29: Playing Recorded Video

    CR-2000 OMEGA User Manual Playing recorded video Viewing on a PC (connecting the Dash Camera) As shown in the figure, when you click “Open folder Connect the Dash Camera to a PC with the USB cable. to view files using Windows Explorer”, the folders containing videos will appear.
  • Page 30 Using the product Viewing on a PC (memory card) As shown in the figure, when you click “Open folder Remove the micro SDHC card from the Dash Camera and to view files using Windows Explorer”, the folders insert it in the adapter. Use the memory card reader for connection with a PC.
  • Page 31: Composition Of Recorded Video

    CR-2000 OMEGA User Manual Composition of recorded video You can play the recorded video in your FINEVu player on a PC as follows. Front camera Google map connection (GPS is optional) Dash Camera's operational voltage Product setting Acceleration information and...
  • Page 32: Firmware Upgrade

    Management Firmware Upgrade Download the latest firmware from the website. Unzip the downloaded firmware and copy it to the root directory of the memory card. Remove the micro SDHC card from the Dash Camera and insert it in the adapter. Use the memory card reader for connection with a PC.
  • Page 33: Cleaning And Storage

    CR-2000 OMEGA User Manual Cleaning and storage Cleaning Storage • • If there is a foreign object on the lens, wipe it down with If you are not using the Dash Camera, remove it from your a soft cloth. vehicle and keep it indoors.
  • Page 34: Troubleshooting

    Troubleshooting The Dash Camera does not turn on. The LCD does not turn on. • • Check if the continuous power cable is connected properly. Check if the Dash Camera has booted properly. (black line: GND / red line: B+ / yellow line: ACC power) •...
  • Page 35 CR-2000 OMEGA User Manual The Dash Camera is recognized on a PC's USB then Nothing is recorded in the video file. disconnected in a moment. • Check if the Dash Camera has booted properly. • Connect the Dash Camera to the USB port of a PC's main •...
  • Page 36: Specifications

    Specifications Item Specification Remarks Model CR-2000 OMEGA Front: 92.5 x 66 x 42mm / 152g The weight of cables and mount excluded Size/weight Rear: 52 x 24 x 24mm / 21g UHS-1 or higher recommended. Additional SDHC Memory capacity micro SDHC...
  • Page 37 Item Specification Remarks Front: 1920 x 1080p @30fps Video Rear: 1920 x 1080p @30fps Video format: MPEG-4 AVC Encoding .mp4 Audio: PCM Voice Built-in microphone Speaker Built-in 8 ohms External Acceleration sensor 3-Axis Acceleration Sensor +2 g/ -2 g Input power 12V 3A If external power is cut off, it will supply stable Batteries...
  • Page 38: Install And Use

    How to install and use FINEVu player FINEVu Player is a software program that plays video files created by Finedigital's car Dash Camera. Download FINEVu Player from http://www.FINEVu.com and install it. Main Screen Once installation of FINEVu player is completed, run the This is the main screen where your video recording is program.
  • Page 39 Playing and viewing recorded videos Recommended PC specifications for FINEVu player Click the Open button in the control bar. Minimum Recommended specifications specifications Windows XP SP3 Windows Vista/7/8 Designate the folder that contains recorded videos. 50MB 70MB or higher Intel Dual Core or higher/ Pentium4 3.0Ghz AMD AthlonX2 or higher 128M...
  • Page 40: Limited Warranty

    This product is guaranteed against manufacturing defects for one (1) year (six (6) months for battery and accessories) from the original date of purchase. Finedigital’s sole obligation in the event of such defects during this period is to repair or replace the defective part or product with a comparable part or product at Finedigital’s sole discretion.

Table of Contents