Page 7
WARNING : Supply pump pressure MUST NOT exceed 1.5 Bar. Recommend pump Fiamma Aqua 8...
Page 8
1) Heat exchanger body 2) Thermostat mounting 3) Exhaust Flue 4) Wind shield 5) Gas burner 6) Gas connection 7) Sealing grommet 8) Gas Solenoid valve 9) Gas Injector 10) Spark Electrodes Checking the spark & flame sense 1) Remove the upper heat plate by loosening the securing 7mm nut.
Page 12
Black Spark Igniter Electronic Control Board...
Page 13
Manufactured by : Hansen Water Heaters Pty Ltd www.hansenproducts.co.za...
Page 14
Exterior Travel Cover Fitting the Exterior cover by pushing it over the flue exhaust. Ensure the Cover is vertically straight and line up the locking clip to the the first slot on the flue vent (Pic 1) PUSH Pic 1 To remove the cover push the locking clip in the side furthest from the face.