Use; Information About Use; Multi Power Pack Charging Process - AEG 97217 Instructions For Use Manual

22
1. Display
2. emergency hammer
3. 13 V input (1 a)
4. 12 V output (2 a)
5. uSB-anschluss (5 V)
6. activation button
7. 19 V output (3.5 a)
8. Jumper leads connection

uSe

Information about use

▪
Some car outlets will only become active once the ignition is turned on. Please
refer to your vehicle's operating manual or contact your specialised garage if you
are unsure.
▪
Do not cover the device during use and ensure proper ventilation.

Multi Power Pack charging process

attention!
▪
remember the vehicle's battery will be discharged when the vehicle is not
running.
▪
regularly check the battery capacity of the Multi Power Pack whilst stored by
pressing the power button (6). Fully charge the Multi Power Pack every approx. 3
months. a deep discharge could damage the device. if the battery capacity is too
low, it is unable to display. the Multi Power Pack must then be charged.
1. Plug the respective connecting cable into the Multi Power Pack jack.
230 V: insert the plug (11) into the 12 V jack (3) on the device.
12 V: insert the plug (10) into the 12 V jack (3) on the device.
2. Plug the 230 V power plug (11) into a mains socket or the car plug (10) into a
12 V car outlet.
3. charging will start. the display will show the battery capacity in percent (50 =
50% battery capacity charged).
4. charging is complete, the display will show „99".
9. leD light
10. 12 V car charging cable
11. 230 V mains adapter
12. adapter connecting cable
13. Jumper leads
14. adapters for mobile devices
15. adapter connecting cable
16. adapters for mobile devices