Willy MICRO Sidewalker Assembly Instructions

Willy Sidewalker—Final Assembly Instructions
Thank you and congratulations on your purchase of a 12" folding MICRO
Sidewalker.
The Micro Sidewalker comes 70% pre-assembled. Below are the final assembly
instructions. They are intended for DIY customers.
NOTE: If any part of the instructions is unclear, or if you are new to final bike assembly
and are unable to get help from a friend, or if you prefer to let a professional do it, we
recommend that you take the Micro Sidewalker to a local area bike shop for final
assembly and safety inspection. (It is approximately 20 to 30 minutes work for a bike
mechanic.)
You will need: 5/8" wrench, #5 Allen key, wire cutter.
PACKING LIST:
Open the box and ensure you have the following:
1) Frame with folding mechanism, front and rear brakes, attached foot platform, rear brake
cable/cable housing.
2) Two identical 12" aluminum wheel sets.
3) Handlebar/stem with hand grips, brake levers and bell.
4) Small box or plastic bag with hardware inside.
Inside the small box or plastic bag:
1) Front brake cable/cable housing.
2) Reflector with nut and washer.
3) Two 90 degree "noodles": the rigid one for front brake, flexible one for rear brake.
4) Two cable ends.
THE FINAL ASSEMBLY:
1) Rotate the front fork 180 degrees so it faces forward.
2) Front wheel: Insert hub and position wheel into the front fork. Lock washers into the
drilled holes in the frame and tighten the 5/8" nuts.
3) Repeat for rear wheel.
4) Handlebar/stem assembly: Slide the handlebar/stem into the head tube to desired
height, and lock with locking arm.
5) Front and rear brake assembly: Use this link as a guide:
http://pedalwithapurpose.wordpress.com/2010/11/02/brake-essentials/