Table of Contents
Advertisement
IPC4100 Hardware Manual
Connect the video out (BNC) connector to the monitor or video input.
③ 3 pin terminal block for D/I
You can use external devices to signal the dome camera to react to events. Mechanical or
electrical switches can be wired to the IN(Alarm In) and GND(Ground) connectors.
GND(Ground)
Note : All the connectors marked GND are common.
Connect the ground side of the Alarm input to the GND connector.
④ 6 pin terminal block for D/O and audio
The dome camera can activate external devices such as buzzers or lights. Connect the device to
the NC(NO)(Alarm Out) and COM(Common) connectors.
⑤ LAN connector (Ethernet)
This is a RJ45 LAN connector for 10/100 Base-T Ethernet.
Figure 14. RJ45 LAN connector
⑥ Terminal block for the Power
Connect the power of AC 24V 850mA to the dome camera.
⑦ Reset Switch (Reset)
Reset switch is used for restarting NVE or resetting NVE as Factory Default (FD). Refer to '4.1.
Factory Default Settings' for detailed procedures. (This function is not implemented yet)
C
UDP Co., Ltd.
16
Advertisement
Table of Contents
