Advertisement
Die Set Installation (cont)
3) Position die set as shown in Figure 7 and slide into tool frame.
Ensure top die screw head (a) is encapsulated by upper die control
arms.
4) Hand tighten thumbscrew by rotating clockwise per Figure 8.
5) Squeeze frame handles to complete a full ratchet cycle.
6) Tool is ready for use.
Figure 7
Figure 8
6
1) Squeeze frame handles until the upper die control arms, Figure 9 (a)
Note: Two ratchet clicks should be heard when properly positioned.
2) Loosen thumbscrew (b) by rotating counter‐clockwise. Ensure no
3) Slide die out of tool frame by pushing from the opposite side shown
4) Re‐install die following the "Die Set Installation" steps 1‐6 shown on
a
Die Set Replacement
are visible in the die cavity.
portion of the screw is present in the die cavity.
in Figure 9.
page 5 and 6.
Die Cavity
b
a
Figure 9
7
Advertisement
