Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Monoprice Z-Wave
Summary of Contents for Monoprice Z-Wave
- Page 2 After receiving the product, please inventory the contents to ensure you have all the proper parts, as listed below. If anything is missing or damaged, please contact Monoprice Customer Service for a replacement. 1x Z-Wave Garage Door Sensor 1x Bracket Holder...
- Page 3 Operating Temperature: +5 ~ +140°F (-15 ~ +60°C) Battery: 1x CR123A INSTALLATION Note: If you are installing a complete Z-Wave system for the first time, please refer to the installation guide of your Z-Wave Interface Controller before installing this Garage Door Sensor.
- Page 4 Z-Wave Interface controller and the LED will flash once. 7. Next, close the garage door. The sensor should send an OFF signal (Basic Set, value: 0x00) to the Z-Wave Interface controller and the LED will flash once. EXCLUSION If you wish to remove the sensor from your network, you will need to "exclude" it.
- Page 5 When the garage door is opened, the sensor will send an ON status report (Basic Set, value: 0xFF) to the controller and all associated Z-Wave devices. When the garage door is closed, it will send an OFF status report (Basic Set, value: 0x00) to the controller and all associated Z-Wave devices.
- Page 6 TECHNICAL SUPPORT Monoprice is pleased to provide free, live, online technical support to assist you with any questions you may have about installation, setup, troubleshooting, or product recommendations. If you ever need assistance with your new product, please come online to talk to one of our friendly and knowledgeable Tech Support Associates.
Need help?
Do you have a question about the Z-Wave and is the answer not in the manual?
Questions and answers