Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for StBernard iPrism
- Page 1 Quick Setup Guide...
- Page 2 If you are going to install Appliance Manager on an XP/SP2 workstation, be aware that the software firewall built into XP/SP2 may prevent discovery of your iPrism. You can prevent this by turning the firewall off ahead of time, or by clicking "Unblock" during the initial launch of Appliance Manager. For further help,...
- Page 3 Step 3. Gather Setup Data iPrism IP address and subnet mask The iPrism IP address and subnet mask for the network or subnet iPrism will join. This is required for appliance discovery, and later, web-based iPrism administration. Example: 192.168.45.92 255.255.255.0...
-
Page 4: Time Settings
Appliance Manager, if applicable to your network. Click “Next”. Enter the IP address of the routing device (next hop relative to Route Default iPrism) providing outbound internet access for iPrism, using your setup data. Click “Next”. Take the default address range, which potentially allows all users Internal Addresses to be filtered by iPrism, click “Next”.
Need help?
Do you have a question about the iPrism and is the answer not in the manual?
Questions and answers