Getting Started; Accessories List; Installing The Stand - Hisense 50K610GW User Manual

Accessories List

USER MANUAL
User Manual Quick Setup Guide
for 50K610GW(50")
Screws:
for 55K610GW(55")

Installing the Stand

NOTES
1. The LCD display is very fragile, and must be protected at all times when removing the base stand. Be sure that no hard or
sharp object, or anything that could scratch or damage the LCD display, comes into contact with it. DO NOT exert pressure
on the front of the TV at any time because the screen could crack.
2. For tabletop use, the TV must be attached to the provided stand as shown on this page.
3. To Wall-Mount, brackets (not provided) must be attached to the TV as shown on next page.
WARNING
Be sure to disconnect the AC power cord before installing a stand or Wall-Mount brackets.
CAUTION
Use a covered table or bench to lay the TV on and handle the TV carefully to prevent damage to the TV screen or cabinet
during assembly.
Follow the illustrations below to complete the installation steps:
1. Secure the stand column to the base plate with the 4 screws (M4×12mm for 50" and M5×12mm for 55") provided. See
Figure 1.
2. Secure the stand cover to the stand column vertically with the 2 screws (M4×12mm for 50" and M5×12mm for 55") provided.
See Figure 2.
3. Secure the stand cover to the stand column horizontally with the 2 screws (ST4×14mm) provided. See Figure 3.
1
4 screws
(M4×12mm for 50" and
M5×12mm for 55")

Getting Started

Quick Setup Guide
Warranty Card
(M4×12mm)×6
(M5×12mm)×10
2
screws
(M4×12mm for 50" and M5×12mm for 55")
Warranty Card
Remote Control
(ST4×14mm)×2 (M5×12mm)×4
(ST4×14mm)×2 (M6×45mm)×4
3
Battery × 2 Spacer×4
(M6×45mm)×4
3
Screw
(ST4×14mm)