Advertisement
Quick Links
Advertisement
Related Manuals for Cadillac Prodigy One.2
Summary of Contents for Cadillac Prodigy One.2
- Page 1 Prodigy One.2 TD-CADICTS-KIT Installation Manual...
- Page 2 Contacts www.intraphex.com support@intraphex.com Support: 810.355.2266 Fax: 810-735-0175...
- Page 3 Contents Dash Pad Bracket AV input Cable Prodigy One.2 4 Pin Touch Cable Monitor Multi Display PCB Prodigy One Data Cable & Connectors CTS Radio T-Harness Bag of Screws & Clips ...
- Page 5 Remove center console trim bezels. use hook tool to release panel from rear. Place panels in safe location to assure they don’t get scratched. Remove gear selector trim bezel. Use hook tool to release panel from rear. Place panel in a safe location Place shifter into “Neutral”...
- Page 7 Remove four 7mm screws from front panel of disc changer. Remove changer assembly and unplug all plugs from rear. Install INTRAPHEX supplied “T-harness”, route wires as necessary to ensure that changer assembly can be installed back into location. Plug male end of INTRAPHEX supplied “T-harness” into rear of changer assembly and reinstall antenna plugs.
- Page 9 Connect 12 volt acc wire. Use Multi-meter to test. Located at BCM, green plug PIN 6, pink wire. Insert INTRAPHEX supplied T-nuts into empty locations shown. Next we will remove the OEM radio LCD, and preset buttons. Remove eight #1 screws securing the panel in place. Gently pull the radio lcd away from dash bezel.
- Page 11 Remove preset buttons from lcd. Remove two #1 screws. Separate buttons from bezel. Add buttons to INTRAPHEX supplied trim bezel, route wires accordingly. Replace two #1 screws. Replace six #1 screws to affix INTRAPHEX supplied trim bezel to the radio panel.
- Page 13 Assembled dash panel with INTRAPHEX supplied bezel. Factory dash pad. Remove t-10 torx screws to separate two pieces. Align dash pad with INTRAPHEX supplied monitor bracket. Use provided screws to attach dash pad to bracket. Assembled dash pad bracket.
- Page 15 Attach dash pad bracket to monitor assemble using INTRAPHEX provided screws Long screws go in back of monitor and short ones go in side of monitor. Steps 31 and 32 can be done after car is re-assembled if you find it easier. With monitor assembly in the up position install two black INTRAPHEX provided dash pad bracket rear set screws.
- Page 17 Replace radio control panel. Replace two 7mm screws. Replace shifter trim bezel. Replace dash trim. Replace dash trim. Replace center console trim bezel...
- Page 18 Reverse (pin 3, lt green @ grey plug in ***NOTE*** Please be sure to set the dip switches for video input according to the chart. Not setting the dip switches correctly may render the prodigy one.2 or the video one inputs inoperative.
- Page 19 Scan the QR code above to see a short video on the operation of the Cadillac PRODIGY ONE.2 kit.