Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Wallpro ID-3000L
-
Page 1: Operating Instructions
CORDLESS IMPACT DRIVER OPERATING INSTRUCTIONS model Id-3000l... -
Page 2: General Operational Precautions
General Operational Precautions The appliance is not intended for use by young children or infirmed persons unless they have been adequately trained by a responsible adult to ensure that they can use the appliance safely and without supervision. Young children should be supervised to ensure that they do not play with the appliance. Consider work area environment. - Page 3 Important Safety Instructions for Charger & Battery Cartridge Caution: To reduce risk of injury, change only specific type rechargeable batteries. Other types of batteries may burst causing personal injury and damage. Before using battery charger, read all instructions and cautionary markings on the batteries and chargers.
-
Page 4: Specifications
Specifications Model No ID-3000L Voltage 14.4V DC No Load Speed 0-2000RPM Max Torque 2000kg/cm Impacts Per Minute 3000 Tool weight 1.53kg (with battery) (battery 0.53kg) Capacity 6mm/10mm Charging Time 1 Hour – Auto Cut-off... - Page 5 View of the Major Components & Accessories Forward/Reverse Rod Bit Holder Main Switch Battery Knob Battery Pack Charger Belt Hook Belt Hook Screw...
- Page 6 Operating Instructions (Slide-In) Installing or Removing Battery Pack (See Fig.1 Fig.2 ) Always switch off the machine before insertion or removal of the battery pack. To remove the battery pack, push the button on the battery pack and pull the tool unit from the battery pack in the direction indicated in Fig.1.
- Page 7 The LED Light on the Charger Power On (Green light flashes slowly) Battery Low (Red light stays illuminated) Battery charged 80% (Green light flashes rapidly) Battery charged 100% (Green light stays illuminated) Battery Pack temperature is too hot or too cold (Red light flashes slowly) Battery Pack malfunction (Red and Green lights stay illuminated) WARNING Charger is plugged into a 100-240V a.c outlet only.
-
Page 8: Tool Operation
Tool Operation CAUTION Always be sure that the machine is switched off and the battery pack is removed before installing or removing the bit. Forward Reverse Fig. 1 Fig. 2 Fig. 3 Installing or Removing Bit To install the bit, pull the retainer in the direction of the arrow and insert the bit into the retainer as far as it will go. - Page 9 Replaceable Carbon Brush Replace the new carbon brush, while the motor is not rotated and the carbon brush is run out. (Change the new motor after the carbon brush has been replaced 2~3 times) Replacement procedure is as follows: • Use T10 size bit to loosen the back cover screws and remove back cover by hand (Fig.1). •...
-
Page 10: Parts & Assembly
Parts & Assembly PARTS NAME PARTS NAME Front Cover & Front Impact Assembly Rear Impact Ass’y Main Switch Washer Forward/Reverse Rod Ring Gear Discharge Protector Bearing Belt Screw Screw Ring Gear Steady Belt Hook Rubber Washer Belt Hook Screw Motor Assembly WLB-14.4V Battery Pack Carbon Brush WLC-UNI Charger... -
Page 11: Warranty
This Warranty will not apply if any of the following occurs during the relevant warranty period: 1. The product is serviced or repaired by anyone other than by a registered and approved Wallpro service agent 2. You use a Product contrary to the technical or operating environment guidelines recommended in its user guide or manual;... -
Page 12: Customer Service
CUSTOMER SERVICE 1300 653 177...