Table of Contents
Advertisement
Menu
Many of the characteristics of the BM-AV2-16SHD can be adjusted in the menu. When
the menu is activated, by pressing the NAV rotary encoder, the top level of the menu will
appear on the video monitor. The items in this level can be selected by rotating the
encoder and then pressing it for approximately 0.5 seconds. The second level will then
appear and the required item selected by rotating the encoder and then pressing it. At this
point in the menu the value of the current parameter can be adjusted. To go back one
step in the menu press and hold the encoder for longer than 1 second.
Tip: Simultaneously pressing the buttons under the bargraphs 15 and 16 will completely
exit the menu.
The characteristics that can be adjusted in the menu are shown below.
Top
l evel
m enu
p age
The top level of the menu carries the main areas of operation of the BM-AV2-16SHD that
can be adjusted.
1. Level meters - This section allows access to the bargraph colour break points and
ballistics.
2. Line levels - The line output level control can be selected here (either fixed level or
controlled by the volume control). The line output can also be muted, or slaved to the
main speaker mute control.
3. Analogue levels - The analogue output level control can be selected here (either fixed
level or controlled by the volume control). The analogue output can also be muted, or
slaved to the main speaker mute control.
4. Dolby - Various aspects of the Dolby operation can be accessed here.
Version
1 .0
BM-‐AV2-‐16SHD
2012
Page
9
Advertisement
Table of Contents
