Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for DèLonghi DEINV27
Summary of Contents for DèLonghi DEINV27
- Page 1 Split Air Conditioner...
-
Page 2: Table Of Contents
CONTENTS Operation and maintenance Notices for operation Notices for use Names and functions of each part Operation of wireless remote control Emergency operation Clean and care Troubleshooting Installation service Notices for installation Installation dimension diagram Install indoor unit Install outdoor unit Check after installation and test operation Installation and Maintenance of Healthy Filter This symbol stands for the items... -
Page 3: Operation And Maintenance
Operation and maintenance-notices for operation ★ ★ ★ Earth: The ground Be sure to pull out the power Select the most appropriate tem- plug when not using the air co- be connected! perature. nditioner for a long time. Keep room cool- er than outside about 5 degree. -
Page 4: Notices For Operation
Notices for operation The airflow direction can be adjusted appro- If the supply cord is damaged, it must be replaced priately. At operating, adjust the vertical airflow by the manufacturer or its service agent or a direction by adjusting the louvers of upward/do- similarly qualified person in order to avoid a wnward direction. -
Page 5: Notices For Use
Notices for use Working principle and special functions for cooling Principle: Air conditioner absorbs heat in the room and transmit to outdoor and discharged, so that ambient temperature decreased, its cooling capacity will increase or decrease by outdoor ambient temperature. Anti-freezing function: If the unit is running in COOL mode and in low termperature, there will be frost formed on the heat exchanger, when indoor heat exchanger temperature decreased below 0... -
Page 6: Names And Functions Of Each Part
Names and functions of each part Indoor unit Air in Air out The pattern in displayer Cool Wireless Remote control Heat remote control Front panel Set temp. Filter Outdoor unit Guide louver Air in Wall pipe Bind tape Connection wire Drainage pipe Air out... -
Page 7: Operation Of Wireless Remote Control
Operation of wireless remote control Names and functions of wireless remote control Note: Be sure that there are no obstructions between receiver and remote controoler; Don't drop or throw the remote control; Don't let any liquid in the remote control and put the remote control directly under the sunlight or any place where is very hot. - Page 8 Operation of wireless remote control Names and functions of wireless remote control This wireless remote control is universal, and it could be used for many units, some buttons of this control which are not available to this unit will not be described below. I FEEL button Press this button once, to turn on the I FEEL function, then the figure of I FEEL...
- Page 9 Operation of wireless remote control Names and functions of wireless remote control This wireless remote control is universal, and it could be used for many units, some buttons of this control which are not available to this unit will not be described below. TIMER ON BUTTON Timer On setting: "ON"...
- Page 10 Operation of wireless remote control Guide for operation- General operation 1. After powered on, press ON/OFF button, the unit will start to run.(Note: When it is powered on, the guide louver of main unit will close automatically.) 2. Press MODE button, select desired running mode, or press COOL or HEAT mode to enter into the corresponding operation directly.
- Page 11 Operation of wireless remote control About lock Press buttons simultaneously to lock or unlock the keyboard. If the remote controller is locked, press any button, the remote control can't work, you must unlock the keyboard. About swing 1. Press swing button continuously more than 2seconds,the main unit will swing back and forth from up to down, and then loosen the button, the unit will stop swinging and present position of guide louver will be kept immediately.
-
Page 12: Emergency Operation
Emergency operation (only on some models) Displayer indicator light control of indoor unit It's a special selective buttonfor the users ,who are not accustomed to the light at sleeping. Get the displayer indicator light on: When setting the light function,the mark will display on the remote controller screen by pressing this button. - Page 13 Emergency Operation (only on some models) Emergency Operation When the wireless remote control is lost or damaged, please use the manual switch, at this time, it is running in Auto Run mode that will not change the temperature setting value and fan speed. The manual switch can be operated as follow: At operation: When the unit stopped running, press ON/OFF button, unit will enter into AUTO...
-
Page 14: Clean And Care
Clean and care Caution Turn power off and pull out the power plug before cleaning air conditioner, or it may cause electric shock. Never sprinkle water on the indoor unit and the outdoor unit for cleaning because it can cause an electric shock. - Page 15 Clean and care Check before use Be sure that nothing obstructs the air outlet and intake vents. Check that whether ground wire is properly connected or not. Check that whether the batteries of air conditioner are changed or not. Check that whether the installation stand of the outdoor unit is damaged or not.
-
Page 16: Troubleshooting
Troubleshooting CAUTION Don't attempt to repair the air conditioner by yourself, it can cause an electric shock or fire. Please check the following items before asking for repair, it can save your time and money. Phenomenon Troubleshooting Not operate immediately when the air Once the air conditioner is stopped, it will conditioner is restarted. - Page 17 Troubleshooting Phenomenon Troubleshooting Has the power been shut down? The unit can not run. Is power plug loosed? Is the circuit protection device tripped off or not? Is voltage higher or lower? (Tested by professionals) Breaking off Is the TIMER correctly used? Is Temp.
- Page 18 Troubleshooting Phenomenon Troubleshooting Indoor unit cannot deliver air. In HEAT mode, when the temperature of indoor heat exchanger is very low, that will stop deliver air in order to prevent cool air. (Within 2min) In HEAT mode, when the outdoor temperature is low or high humidity, there are much frost be formed on the outdoor heat exchanger, that the unit will automatically defrost, indoor unit stop...
-
Page 19: Notices For Installation
Notices for installation Important Notices The unit installation work must be done by qualified personnel according to the local rules and this manual. Before installating, please contact with local authorized maintenance center, if unit is not installed by the authorized maintenance center, the malfunction may not solved, due to discommodious contacts. -
Page 20: Notices For Installation
Notices for installation Outdoor Unit Installation Position Selection Select a location from which noise and outflow air emitted by unit will not inconvenience neighbors, animals, plants. Select a location where there should be sufficient ventilation. Select a location where there should be no obstructions cover the inlet and outlet vent. The location should be able to withstand the full weight and vibration of the outdoor unit and permit safe installation. -
Page 21: Installation Dimension Diagram
Installation dimension diagram Installation dimension diagram Space to the ceiling Above Space to the wall Above Above Space to the wall Above Above Air outlet side Space to the floor The dimensions of the space necessary for correct installation of the appliance including the minimum permissible distances to adjacent structures Space to the obstruction Air inlet side... -
Page 22: Install Indoor Unit
Install indoor unit Install the rear panel 1.Always mount the rear panel horizontally. Due to the water tray of indoor unit has been adopted the both-way drainage design, the outlet of water tray should be adjusted slightly down when installing, that is taking the outlet of the water tray as the center of a circle, the included angle between the evaporator and level should be 0 or more, that is good for condensing water drainage. -
Page 23: Install Indoor Unit
Install indoor unit NOTE: When connecting the electric wire if the wire length is not enough, please contact with the authorized service shop to buy a exclusive electric wire that is long enough and the joint on the wire are not allowed. The electric wiring must be correctly connected, wrong connection may cause spare parts malfunction. -
Page 24: Install Outdoor Unit
Install outdoor unit Electric wiring Disassemble the handle on the outdoor unit right side plate. Take off cord anchorage. Connect and fix power connect Handle cord (for cooling and heating unit,connect and fix power connect cord and signal control wire)to terminal block. ON-OFF: N(1) blue black violet orange... -
Page 25: Check After Installation And Test Operation
Check after installation and test operation Check after installation Items to be checked Possible malfunction Has it been fixed firmly? The unit may drop, shake or emit noise. It may cause insufficient cooling(heating) Have you done the refrigerant leakage test? capacity It may cause condensation and dripping. -
Page 26: Installation And Maintenance Of Healthy Filter
Installation and Maintenance of Healthy Filter Installation Instructions 1. Forcibly pull the panel for a specific angle from the two ends of the front panel according to the arrow direction. Then pull the air filter downwards to remove it. (See Fig.a) Fig. - Page 27 On - Off (****) °C °C (****) The models correspond respectively to the following De Longhi product names: DECON28, DECON35, DECON52, DECON73, DECON81...
- Page 28 - INVERTER - (****) °C °C (****) The models correspond respectively to the following De Longhi product names: DEINV27, DEINV35, DEINV52, DEINV63, DEINV82...
- Page 32 5717310161/12.10/04...
Need help?
Do you have a question about the DEINV27 and is the answer not in the manual?
Questions and answers