Louroe Electronics TLO Installation And Operating Instructions

6955 VALJEAN AVE, VAN NUYS, CA 91406
PH: (818)994-6498 / FAX: (818)994-6458
techsupport@louroe.com / www.louroe.com
DESCRIPTION
The TLO is a two-way speaker with microphone and re-entry horn for high volume
penetration. Weatherized for outdoor use, it is a microphone and speaker within one
housing. In operation, the TLO provides both listen and talkback capabilities
between the remote zone and Louroe base station, or with other compatible audio
receiving devices such as Louroe AOP-SP70.
MICROPHONE CONNECTION OF TLO
The short cable extending from the back of the TLO is the microphone connection and consists of three wires: red, black
and bare. Using recommended wiring (West Penn 356 or equivalent), make microphone connections using 20 gauge
wire nuts, and matching
SPEAKER CONNECTION OF TLO
Speaker connection is located near the rear of the TLO and has a plexiglass window. Remove window and connect the
speaker portion of West Penn 356 (green and white wires) to the two terminal screws marked 1 and 2.
1 through 7
power tap settings
Speaker connection
(WHITE-negative)
POWER TAP SETTINGS
Located above the speaker connection is a set screw with a dial numbered 1 through 7. Using a small screw
driver, adjust the set screw to correspond to the proper power tap setting with the following Louroe audio base
stations.
IF TLO IS CONNECTED TO BASE STATION MODELS:
AP-1TB through AP-16TB
DG 12II and DG 25III
If TLO is to be connected to Louroe AOP-SP70 conversion unit
for interfacing with a DVR or PC Soundcard, use setting
®
INSTALLATION AND OPERATING INSTRUCTIONS
red wire with red , black with black and
Green speaker wire goes to position 2 (positive)
White speaker wire goes to position 1 (negative)
set screw
3 5
2 6
1 7
Speaker connection
(GREEN-positive)
2
1
1 TLO per zone
2-4 TLO's per zone using MLA-6 Mixer
TLO
OUTDOOR SPEAKER/MICROPHONE
bare wire with bare
4 Conductor consisting of:
unshielded, 18 gauge (speaker
connection)
Setting
Page 1 of 4
MODEL TLO
wire. See diagram page 2.
see diagram below
WIRING REQUIREMENTS
2 Conductor shielded,
20 gauge with 22 gauge drain
(microphone connection)
2 Conductor
West Penn 356 or equivalent
Wattage
#1 1.8W
#4 15.0W
#2 3.7W
#2 3.7W
tlo inst 3/15