1. Manuals
  2. Brands
  3. Harris Manuals
  4. Switch
  5. CCS-NET-24
  6. Initial setup manual

Harris CCS-NET-24 Initial Setup Manual

Extreme networks summit x250e series 24-port fast ethernet stackable switch
Hide thumbs
1
2
3
4
5
6

Advertisement

Table of Contents

CCS-NET-24
Extreme Networks Summit® X250e
Series 24-Port Fast Ethernet Stackable
Switch
Initial Setup Guide
175-100067-00, Edition A
December 2008

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CCS-NET-24 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Harris CCS-NET-24

Summary of Contents for Harris CCS-NET-24

  • Page 1 CCS-NET-24 Extreme Networks Summit® X250e Series 24-Port Fast Ethernet Stackable Switch Initial Setup Guide 175-100067-00, Edition A December 2008...

  • Page 2: Copyright Information

    This publication could include technical inaccuracies or typographical errors. Changes are periodically added to the information herein; these changes will be incorporated into new editions of the publication. Harris Corporation may make improvements and/or changes in the product(s) and/or the program(s) described in this publication at any time.

  • Page 3: Management Interfaces

    The out-of-box configuration of the Extreme Networks Summit X250e (P/N CCS-NET-24) is sufficient to support a small (up to 24 devices), stand-alone, single-switch network of Harris router and router control products. Configuration No specific configuration steps are required to enable basic operation.
  • Page 4 7. At the password prompt, press the Enter key. By default, there is no password. Note If you must establish a password, use harris (all lower-case) as the password for consistency with other Harris-supplied switches. 8. Continue pressing Enter (to accept the switch’s default settings) until the switch command prompt appears.
  • Page 5 Setting Switch IP Address Once the switch prompt appears, the following command may be used to set the switch’s IP address to 192.168.100.2, which is compatible with the default Leitch/Harris router IP address and subnet settings (address=192.168.100.250, subnet=255.255.255.0). Press <Enter> at the end of each line to execute the command: X250e-24t.1 #configure vlan "default"...
  • Page 6 Preliminary—Contents are proprietary and confidential. Do not photocopy or distribute. CCS-NET-24 Initial Setup Guide Saving the Configuration and Ending the Terminal Configuration Session Press <Enter> at the end of each line to execute the command. • To save the configuration, enter the following command: X250e-24t.1 #save...

Table of Contents