CT WP600 Installation Instructions

A Division of SCARECROW BIO-ACOUSTIC SYSTEMS LIMITED
WALL MOUNT MICROPHONE WP600
WP600 is designed for use as a wall mounted CALL POINT and comprises
a rugged dynamic microphone and momentary PRESS-TO-TALK switch
fitted to a UK double switchplate, designed to fit in back boxes of at least
40mm depth, surface or flush mount according to the installation needs.
The switchplate is built from 3mm aluminium and powder coated in hard
wearing polymer.
Plug-on screw terminations allow for the host system wiring to be completed
before installing WP600.
The 600ohm dynamic microphone capsule is shock-mounted and pin proof,
the open cell foam used is self draining; WP600 is protected against abuse
and misuse.
The push button PRESS TO TALK switch can be pre-selected on its host
printed circuit to provide either open circuit and short circuit 'at rest' status
for both MICROPHONE and ACCESS pairs.
The Old Dairy, Straight Half Mile, Maresfield, East Sussex, TN22 2HH, England
Telephone: +44(0) 1825 766363 Fax: +44(0) 1825 766361 UK
E-mail: sales@communication-technology.co.uk Website: www.communication-technology.co.uk
REGISTERED IN ENGLAND NO. 01568506 VAT REGISTRATION NO. GB680 0269 46
REGISTERED OFFICE: 20 SPRINGFIELD ROAD, CRAWLEY, WEST SUSSEX, RH11 8AD

INSTALLATION INFORMATION

CONNECTIONS: *MODE SELECTION*
MICROPHONE:
Normally closed: place 'jumper' over N/C
Normally open : place 'jumper' over N/O
ACCESS:
Normally closed: place 'jumper' over N/C
Normally open : place 'jumper' over N/O
* INDICATES CIRCUIT STATUS WITH
PRESS-TO-TALK BUTTON AT REST