Advertisement
Quick Links
WARNING: If the information in this manual is not followed exactly, a fire or explosion may
result causing property damage, personal injury, or loss of life.
For your safety
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other
appliance.
What to do if you smell gas
•
Do not try to light any appliance.
•
Do not touch any electrical switch; do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's
instructions.
•
If you cannot reach your gas supplier, call the fire department.
Installation and service must be performed by a qualified installer, service agency or the gas
supplier.
WARNING: Improper installation, adjustment, alteration, service or maintenance can cause
injury or property damage. Read the installation, operating and maintenance instructions
thoroughly before installing or servicing this equipment.
URBAN FIRE -2-
Propane / Natural Gas
Outdoor Gas Fireplace
Installation and Operating Instructions
WARNING: For Outdoor Use Only.
Retain this manual for future reference
Certified by the CSA
(Canadian Standards Association)
CSA 4.96 U.S. (3rd Ed.),
Outdoor Gas Fireplace
CGA CR97‐003
Page 1 of 22
Advertisement
Related Manuals for UrbanFire 2
Summary of Contents for UrbanFire 2
- Page 1 URBAN FIRE -2- Propane / Natural Gas Outdoor Gas Fireplace Installation and Operating Instructions Certified by the CSA (Canadian Standards Association) CSA 4.96 U.S. (3rd Ed.), Outdoor Gas Fireplace CGA CR97‐003 WARNING: For Outdoor Use Only. WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury, or loss of life.
-
Page 2: Table Of Contents
14 & 15 MAINTENANCE ..................Maintenance Safety ................Recommended Service ................. Burner Cleaning ..................Trouble Shooting ..................Replacement Parts ................. Warranty ....................19 & 20 Urban Fire Corp. 103 South Belair Drive Woodbridge, Ontario, L4H 2N4 Canada 1-888-337-4989 Page 2 of 22... -
Page 3: 1.1 Specifications
# 42 DMS LPG ORIFICE SIZE: @ 0-2000’ # 34 DMS NG Clearances to combustibles Sides: 36” (91.44 cm) Floor: Ceiling: 72” (183 cm) * Urban Fire -2- can be placed on a combustible base. Page 3 of 22... -
Page 4: Dimensions & Installation Codes
APPLIANCE DIMENSIONS Figure 1 URBAN FIRE -2- 36” W x 36” L x 16” H INSTALLATION CODES Installation must conform to local codes or in the absence of local codes, installation must conform to the National Fuel Gas Code, ANSI Z233. 1, or the current CAN/CGA B149.05 Installation Codes. In the state of Massachusetts, this product can only be installed by a licensed plumber or a licensed gas fitter. -
Page 5: General Safety
GENERAL SAFETY • Solid fuels shall not be burned in this fireplace. • Keep the appliance area clear and free from combustible materials, gasoline and other flammable vapors and liquids. • Inspect the burner prior to each use, if the burner is damaged it must be replaced prior to use. NOTE: Use only with burner part# UFP 1-02-1 •... -
Page 6: Lighting Instructions
WARNING: Cover must be removed when burner is in operation. This appliance is equipped with a piezo electric ignition device. Be aware and look for proof of ignition spark. If there is not ignition spark replace piezo ignitor device –OR‐ light pilot manually. Page 6 of 22... -
Page 7: Lp Gas Safety Information
Inspect the hose assembly for damage prior to each use. If the hose is damaged or there are signs of excessive abrasion or wear replace the hose. Use only the pressure regulator and hose assembly supplied with the appliance. Replace the regulator hose assembly only with part number UFP LP12‐08 these are available only from approved dealer ‐OR‐ Urban Fire. The specific size of cylinder(s) to be used with this gas fireplace is recommended not to be below or exceed 20 lbs. (9 kg) capacity. Ensure cylinder is secured, upright, on a level non‐combustible base. If a larger TC or DOT cylinder is to be used. Ensure that the cylinder is safely secured, upright on a non‐combustible base, located a minimum of 10ft from the fireplace and in a ventilated space. Do not place a propane cylinder for use with this appliance on a non‐ combustible base ‐ even snow. Snow around the base of the cylinder foot ring could melt and the cylinder could fall over delivering liquid propane to the unit. ... -
Page 8: Lp Gas Cylinder Connection
LP GAS CYLINDER INSTALLATION Tank Stabilizer LP GAS CYLINDER CONNECTION Figure 1 The LP cylinder must include a collar to protect the cylinder valve. The cylinder supply system must be arranged for vapor withdrawal. This appliance uses a “Type 1” cylinder connection device. See above for proper connection instructions. When disconnecting and removing the gas cylinder, from the appliance, always be sure to adhere to the following items: •... -
Page 9: Leak Testing
How to Leak Test Your Appliance • Mix a solution of liquid soap and water in a small container. 50% soap and 50% water. • Make sure that the gas supply is turned on. For LP gas appliances make sure that the valve on the gas cylinder is turned on. -
Page 10: Installation & Safety Notes
INSTALLATION & SAFETY NOTES Read all instructions before starting installation and follow them carefully during installation to ensure maximum benefit and safety. Failure to follow these instructions will void your warranty and may present a fire hazard. See the warranty at the back of this manual for disclaimers regarding improper installation. -
Page 11: Initial Firing
INITIAL FIRING When lit for the first time, the appliance may emit an odor resulting from evaporation of paint and lubricants used in the manufacturing process. This is normal and will subside after the unit has run for an hour or so. MANIFOLD PRESSURE REGULATOR ADJUSTMENT The manifold pressure regulator controls gas input and flame height, and is pre-adjusted at the factory. -
Page 12: Installation And Tank Assembly
There mus st be a mini mum of 24 in nches (2 feet t) of clearan nce from the e side of the e table to an comb bustibles. 3. Place... -
Page 13: Glass Placement
Page 13 of 22... -
Page 14: Natural Gas Conversion
1. Using two adjustable wrenches disconnect propane hose, 3/8 flare fitting and propane pilot regulator as shown above. Using gas pipe compound, attach Natural Gas pilot regulator and 3/8 flare fitting. 4. Remove orifice by removing support nut attached to bracket. 6. Reattach converted orifice to supporting bracket with nut. Leak check 5. Remove LPG orifice tip and replace with a soap and water solution. with NG (larger opening) orifice tip. Page 14 of 22... - Page 15 7. Take protective cover box off of the pilot assembly by removing the mounting screws located on the top side of the pilot assembly. This will allow you to access the pilot assembly. Take an adjustable wrench and loosen the pilot flame counter clockwise. This will allow you access to the pilots’ orifice. 8. Slide tab to Natural Gas position (slightly larger hole). Re‐fasten pilot flame with wrench clockwise. Soap check. Page 15 of 22...
-
Page 16: Maintenance
MAINTENANCE MAINTENANCE SAFETY Turn off the gas to the main burner and allow the fireplace to cool for 30 minutes before servicing. Service and repair should be done by a qualified service person. The appliance should be inspected before use and at least annually by a qualified service technician. It is important that the access door compartment and burner be kept clean to provide for adequate combustion and ventilation airflow. -
Page 17: Trouble Shooting
8. Point burner tube below burner outlet holes B. No gas or low gas pressure 1. Gas line shut off 1. Turn on shut-off valves 2. Air in gas lines 2. Purge gas lines 3. Connect all gas lines Gas lines may not be connected Low pressure may be caused 4. -
Page 18: Replacement Parts
Page 18 of 22... -
Page 19: Warranty
Please register your product immediately at www.urbanfire.ca or call 1‐888‐337‐4989 x 3 Page 19 of 22... - Page 20 Page 20 of 22...