Summary of Contents for Microtronics PIC Lab-II
- Page 1 Microtronics Pakistan Microtronics Pakistan | www.electronicspk.com| PIC Lab II Manual [1] PIC Lab-II Motherboard User Manual Microtronics Pakistan...
- Page 2 Microtronics Pakistan | www.electronicspk.com| PIC Lab II Manual [2] ongratulations on purchase of PIC Lab-II development board. The board supports most com- monly used 40 Pin Mid range PIC microcontroller units, and has on-board many commonly used peripheral devices. All I/O lines are available through separate, well marked headers for daugh- ter boards, or projects.
- Page 3 Switch, in appropriate topics. LED Indicators (PORTC.0 … PORTC.7) PIC Lab-II has 8 Led indicators connected to PORTC of the microcontroller. The LEDs are connected through 220 ohms current limiting resistor, and are sourced by the microcontroller. Therefore a logical 1, or on state of the microcontroller pin will turn the corresponding LED ON.
- Page 4 Microtronics Pakistan | www.electronicspk.com| PIC Lab II Manual [4] The infrared –Sensor can be enabled or disabled using DIP-Switch 3. Push Switches There are five push switches available on board. These switches have all 10K pull up resistors and will be active low.
- Page 5 BAUD speed of 115K asynchronous serial communication. Therefore configure your windows terminal to use 115K speed. Load the program hex file, which you want to load. Connect serial cable to PIC Lab-II board. Turn power ON, press reset button, and immediately click on Write button on boot loader windows application. This will immediately write the software into your microcontroller.
- Page 6 Microtronics Pakistan | www.electronicspk.com| PIC Lab II Manual [6] microcontroller will be programmed by LVP. This is usually all set by the programmer itself. All you need to know is that the programmer might use RB3, RB6 and RB7 so, your application must not be using them at-least at the time of programming, the pins should be free.
- Page 7 LED1 4004 7805 LCD1 LCD Vout Charcter LCD ON-OFF + C2 100u LED9 LED8 LED7 LED6 LED5 LED4 LED3 LED2 100u 1.5K 20MHz MCLR PORTC OSC1/CLKIN OSC2/CLKOUT MCLR/VPP RC0/T0OSO/T1CKI RC1/T0OSI RC2/CCP1 RC3/SCK/SCL RC4/SDI/SDA RA4/T0CKI RC5/SDO RA5/SS RB0/INT RD0/PSP0 RD1/PSP1 RD2/PSP2 RD3/PSP3 RD4/PSP4 RD5/PSP5...
Need help?
Do you have a question about the PIC Lab-II and is the answer not in the manual?
Questions and answers