1. Manuals
  2. Brands
  3. Emotiva Pro Manuals
  4. Amplifier
  5. Control Freak
  6. User manual

Emotiva Pro Control Freak User Manual

Hide thumbs
1
2
3
4

Advertisement

Table of Contents

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Control Freak and is the answer not in the manual?

Questions and answers

Summary of Contents for Emotiva Pro Control Freak

  • Page 2: Specifications

    To avoid messy wires, the inputs and outputs for the Control Freak are all located on a handy control pod - which is attached to the rear of the Control Freak’s base by a single two meter umbilical cable. Instead of simply using a junction box, which would only allow cables to enter and exit from certain directions, each input and output consists of an individual in-line connector on a short cable.
  • Page 3 CONTROL FREAK The Control Freak has two inputs and two outputs. Simply plug the two Input cables from the Control Freak into the outputs on your source component, and plug the interconnects going to your powered monitors or other destination component into the connectors labeled Output on the Control Freak.

Table of Contents