Table of Contents
Advertisement
Wireless N Broadband Router
6.2 Dynamic IP (DHCP)
Select this option only if you have a DHCP-enabled router on your
network to assign an IP address to your AP. Otherwise use the
static IP option.
Note:
1. If you change the device' LAN IP address, you have to enter the new
one in your browser to get back into the web-based configuration
utility.
2. If you are using the dynamic IP option, you need to first go to the
management interface of the DHCP-enabled router (where your AP
obtains IP) to check your AP's IP address and then use this IP to log in
to your AP's management interface. So, do not use this option unless
you have authorized access to the router to check your AP's IP address
therein or you don't need to go to AP's management interface to
configure any settings.
29
Advertisement
Table of Contents
