Philips DVP3560K Service Manual page 21

Remote reception is insensitive or fails.
Remote reception is
insensitive or fails.
Check if the remote
control works properly.
Check if the power supply
voltage to the remote censor
is normal
Use an oscilloscope to check if there
is output waveform from the first pin
IR of the remote censor after pressing
button on the remote control.
Check if there is IR
signal on pin 33 of U20
Correct connection
Go
Yes
Yes
Yes
No
5-9
No
Check battery
No
Check R315 C315
No
REM301(PIN1 - RC waveform)
Yes
Change U20
IR waveform
Trouble shooting chart