FujiFilm Finepix S8100 fd Basic Manual page 150

[SHOOTING MENU]
I
g
Custom white balance
CD
Select
g
custom white balance
(~p.73).
®
Hold a piece of white paper under the light source for
setting the white balance, so that it fills entire the
screen. Then press the shutter button to set the white
balance.
.
"'".
Setting the menu
(~p.73)
Set the exposure
ISOlOG
compensation again, using
a negative value (-) when
[OVER] appears and a
positive value (+) when
[UNDER] appears
(~p.63).
BACK '
Example
You can change the white balance for a photographed image
by using colored paper instead of white paper.
82
t1
MEMO
To use the white balance set previously, press the MENU!
OK without pressing the shutter button.
@
When the correct exposure is measured,
[COMPLETED!] appears. Press MENU/OK to confirm
the setting.
t1
MEMO
• In AUTO mode, the correct white balance may not be
achieved for subjects such as close-ups of people's
faces and pictures taken under a special light source.
Select the correct white balance for the light source.
• When the flash fires, the white balance (except for
custom white balance) setting for the flash is used.
Consequently, to achieve a particular effect, the flash
mode should be set to Suppressed flash (~p.67).
• The specified custom white balance is retained until it is
reset. This setting is retained even if the batteries are
removed.
• The color tones may vary depending on the shooting
conditions (light source, etc.).
• After taking the picture, check the image color (white
balance).
• Explanation of Terms "White Balance" (-p.157)
• When
[~
AUCTION MODE] is selected, custom white
balance cannot be set.