Lindy 32450 User Manual

Specifiche Tecniche
Modello IPower Switch 4 LITE
Art. 32450
Porta Remote Access Ethernet 10Base-T, RJ-45
Prese di alimentazione IN/OUT 1x IEC-Plug / 4x IEC-Socket
Parametri di alimentazione Ingresso 230V AC 2300VA (10A@230V)
Parametri alimentazione Uscite Max. 8A per ogni Uscita, 10A totale
Temperatura Operativa +5°C ... 40°C, esclusivamente per uso in interni
Umidità 5 ... 85% rel. non condensata
Misure (HXLXP), Peso 44.5 (1U) x 441 x 63 mm, 1.4kg
Direttiva Europea EMC 89/336/EEC Marchio CE
Questa apparecchiatura è conforme alle specifiche CE menzionate nella Direttiva Europea 89/336/EC a agli
Standards EN55022 e EN55024
FCC Warning
This equipment has been tested and found to comply with the limits for a Class B Digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
Consult the dealer or an experienced technician for help
You are cautioned that changes or modifications not expressly approved by the party responsible for
compliance could void your authority to operate the equipment.
For Commercial Use
Tested to Comply with
FCC Standards
© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - SECOND EDITION (JAN 2005)
IPower Switch 8 LITE
Art. 32451
2x IEC-Plug / 8x IEC-Socket
230V AC 2x2300VA, 2x(10A@230V)
Max. 8A per ogni uscita, 2x10A totali
44.5 (1U) x 788 x 63 mm, 2.3kg
IPower Strip LITE
Manuale dell'utente
(Versione 8/2004, Versione Firmware 1.18; la versione fornita può essere più recente)
Modello 1 IN / 4 OUT: LINDY Art. 32450
Modello 2 IN / 8 OUT: LINDY Art. 32451
www.LINDY.com
For Commercial Use
Tested to Comply with
FCC Standards
© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - SECOND EDITION (JAN 2005)
Italiano