Table of Contents
Advertisement
Advertisement
Table of Contents
Summary of Contents for Grundig ST 3211
- Page 2 St 3211 ________________________________________________________ ac 9V-10V HEADSET FOOT CONTROL ac 9V-10V HEADSET FOOT CONTROL...
- Page 3 St 3211 ________________________________________________________ ac 9V-10V ac 9V-10V HEADSET HEADSET FOOT CONTROL FOOT CONTROL t e n o - C a s s e t t e 3 0 ßW E J E C T t 3211 ßQ S P E A K E R / E A R P O W E R ß`...
- Page 4 St 3211 ________________________________________________________ Made in Germany Fabriqué en Allemagne S P E E D B AC K S PAC E ßE ßR...
-
Page 6: Mains Connection
______________________________________________________ Mains connection With the NT 683 GB mains unit. This mains unit can be used to operate all Grundig office equipment. It can be connected to IT mains with a maximum line-to- line current of 250 V. Connect the mains cable to the alternating voltage mains 230V ~, 50Hz…60Hz. -
Page 7: Switching On And Off
PREPARATION _______________________________________________ Switching on and off With the » – POWER« button. – The operating lamp is on » «. Note: Your unit and the mains unit are disconnected from the alternating voltage system only when the mains plug has been removed from the mains socket! Stand by If you do not select a function within a 10 minute period, the unit... -
Page 8: Volume And Sound
PLAYBACK ____________________________________________________ … using the speaker on the unit Click the speaker button down. … using accessories such as the 568 GBS swingphone. Click the speaker button out. Note: The maximum playback volume is 95 dB (A) when using heaphone accessories. Starting and stopping »... -
Page 9: Playback Speed
PLAYBACK ____________________________________________________ Playback speed … with the speed adjuster “SPEED” (on the bottom); locks at in the middle position (normal speed). You can adjust the playback speed when a foot control 536 or a hand control 541 is connected. Short rewind …... - Page 10 ERASING _______________________________________________________ To erase longer text passages an entire steno-cassette: Wind the tape to the desired position. From the operating mode Stop Press (approx. 2 sec.) until you hear the index signal, then press for »Fast erase« reverse press for »Fast erase« forward –...
-
Page 11: Operation
FOOT CONTROL 536 _____________________________________ Connection Plug the foot control plug into the socket. HEADSET FOOT CONTROL HEADSET FOOT CONTROL Operation You can operate the foot control with both feet. You can rest the foot that you are not using on the middle section. Switch options: right pedal = start left pedal... -
Page 12: Care And Maintenance
CARE AND MAINTENANCE ____________________________ Housing Only clean the machine with a soft cloth suitable for removing dust. Polish and cleaning agents can damage the surface. Liquids should not be allowed to penetrate the inside of the unit. Parts that come into contact with the tape You should check regularly within the steno-cassette compartment for dust and for dirt caused by tape usage. - Page 13 Use only original replacement parts. The mains cable must only be replaced by a specialist. In case of malfunctions, contact your dealer: Environment-friendly materials – environment-compliant packing: Grundig dictation machines are conceived and fabricated according to the highest environmental requirements.
- Page 14 TECHNICAL DATA __________________________________________ steno-cassette 30 Tape: capstan Drive system: 2.38 cm/s; Tape speed: can be adjusted by approximately ±15 % approximately 90 seconds. Rewind time: 200 mW Output power: Maximum playback volume when using a headset: 95 dB (A) 100 - 5000 Hz Frequency Response: 45 mm Ø...
- Page 15 Grundig Business Systems GmbH Weiherstr. 10 95448 Bayreuth Germany 36122 942 0205 03/2013...